Nissan Titan. Instruction — part 44
ACTUATOR AND ELECTRIC UNIT (ASSEMBLY)
BRC-117
< UNIT REMOVAL AND INSTALLATION >
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
Installation is in the reverse order of removal.
CAUTION:
• To install, use a flare nut crowfoot and torque wrench (commercial service tools).
• Always tighten brake tubes to specification when installing.
• Do not reuse drained brake fluid.
• After installation of the ABS actuator and electric unit (control unit), perform the following.
- Refill brake system with new brake fluid. Then bleed the air from the system. Refer to
.
- Adjust the steering angle sensor. Refer to
BRC-8, "ADJUSTMENT OF STEERING ANGLE SENSOR
NEUTRAL POSITION : Special Repair Requirement"
- Calibrate the yaw rate/side/decel G sensor. Refer to
BRC-9, "CALIBRATION OF DECEL G SENSOR :
.
BRC-118
< UNIT REMOVAL AND INSTALLATION >
[VDC/TCS/ABS]
STEERING ANGLE SENSOR
STEERING ANGLE SENSOR
Removal and Installation
INFOID:0000000009883747
REMOVAL
1. Remove spiral cable. Refer to
SR-6, "Removal and Installation"
.
2. Remove the screws and remove the steering angle sensor.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
After installation of spiral cable, adjust steering angle sensor. Refer to
STEERING ANGLE SENSOR NEUTRAL POSITION : Special Repair Requirement"
YAW RATE/SIDE G SENSOR
BRC-119
< UNIT REMOVAL AND INSTALLATION >
[VDC/TCS/ABS]
C
D
E
G
H
I
J
K
L
M
A
B
BRC
N
O
P
YAW RATE/SIDE G SENSOR
Removal and Installation
INFOID:0000000009883748
REMOVAL
1. Remove center console (if equipped). Refer to
IP-24, "Disassembly and Assembly"
2. Remove the front center seat (if equipped). Refer to
SE-34, "Removal and Installation - Front Seat
3. Remove yaw rate/side/decel G sensor nuts.
CAUTION:
• Do not use power tools to remove the yaw rate/side/decel G sensor.
• Do not drop or strike the yaw rate/side/decel G sensor.
4. Disconnect harness connector and remove the yaw rate/side/decel G sensor.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• Do not drop or strike the yaw rate/side/decel G sensor.
• After installation, calibrate the yaw rate/side/decel G sensor. Refer to
.
1.
Yaw rate/side/decel G sensor
Front
ALFIA0330ZZ
BRM-1
BODY EXTERIOR, DOORS, ROOF & VEHICLE SECURITY
C
D
E
F
G
H
I
J
L
M
SECTION
BRM
A
B
BRM
N
O
P
CONTENTS
BODY REPAIR
VEHICLE INFORMATION . . . . . . . .
BODY EXTERIOR PAINT COLOR . . . . . .
Body Exterior Paint Color . . . . . . . . . . ..
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
Precaution in Repairing High Strength Steel . . .....
Handling Precaution for Plastics . . . . . . . ...
PREPARATION . . . . . . . . . . .
REPAIRING MATERIAL . . . . . . . . . .
Foam Repair . . . . . . . . . . . . . . .....
BODY COMPONENT PARTS . . . . . . .
Body Component Parts . . . . . . . . . . ...
UNIT REMOVAL AND INSTALLATION . ..
CORROSION PROTECTION . . . . . . .
Corrosion Protection . . . . . . . . . . . .
Body Sealing . . . . . . . . . . . . . . ...
BODY CONSTRUCTION . . . . . . . . ..
Body Mounting, Crew Cab . . . . . . . . . ...
Body Mounting, King Cab . . . . . . . . . .
Body Construction . . . . . . . . . . . . ...
Rear Body . . . . . . . . . . . . . . . .
BODY ALIGNMENT . . . . . . . . . . ..
Body Alignment . . . . . . . . . . . . . ...
REPLACEMENT OPERATIONS . . . . . ...
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст