Nissan Titan. Instruction — part 105
FRONT DOOR LOCK
DLK-129
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
4. Remove the door side grommet, and the bolt (
) that retains
the outside handle bracket.
5. While pulling the outside handle, remove the door key cylinder
assembly or outside handle escutcheon in order shown.
6. Separate the key cylinder rod from the door key cylinder assembly (if equipped).
7. While pulling the outside handle, slide it toward rear of vehicle to
remove in order shown.
8. Remove the front gasket (1) and rear gasket (2).
JMKIA0025ZZ
LIIA1971E
ALKIA0900ZZ
ALKIA0893ZZ
DLK-130
< REMOVAL AND INSTALLATION >
FRONT DOOR LOCK
9. Remove the bolts (1) and separate the door lock assembly (2)
from the door.
CAUTION:
Do not reuse bolts.
10. While pulling the outside handle bracket, slide it toward the front
of the vehicle to remove it and the door lock assembly as shown.
: Front
11. Disconnect the door lock actuator electrical connector.
12. Separate the outside handle cable connection (1) from the out-
side handle bracket.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
To install the key cylinder rod, be sure to rotate the key cylinder rod holder until a click is felt.
Disassembly and Assembly
INFOID:0000000009878844
DOOR KEY CYLINDER ASSEMBLY
Release the door key cylinder escutcheon pawls to remove the door key cylinder.
AWKIA1768ZZ
ALKIA0895ZZ
ALKIA0896ZZ
1.
Door key cylinder assembly
2.
Key cylinder assembly
3.
Door key cylinder escutcheon
ALKIA0897ZZ
REAR DOOR LOCK
DLK-131
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
REAR DOOR LOCK
Component Structure
INFOID:0000000009878845
KING CAB
AWKIA1727GB
1.
Rear upper door lock striker
2.
Rear door handle
3.
Rear lower door lock striker
4.
Lower latch cable
5.
Rear lower door latch
6.
Rear door lock assembly
7.
Inside handle
8.
Upper latch cable
9.
Rear upper door latch
DLK-132
< REMOVAL AND INSTALLATION >
REAR DOOR LOCK
CREW CAB
Removal and Installation
INFOID:0000000009878846
REMOVAL
1. Remove the rear door finisher. Refer to
INT-10, "Removal and Installation"
.
2. Remove the vapor barrier.
3. Remove the door side grommet and the bolt (
) that retains the
outside handle bracket.
AWKIA1726GB
1.
Inside handle
2.
Rear door lock knob
3.
Lock knob cable
4.
Inside handle cable
5.
Rear door lock/remote control as-
sembly
6.
Outside handle cable
JMKIA0025ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст