Nissan Qashqai (2007-2010). Manual — part 1451
HEADLAMP WASHER DOES NOT OPERATE
WW-95
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
HEADLAMP WASHER DOES NOT OPERATE
Description
INFOID:0000000001115040
Headlamp washer does not operate linked to front washer operation.
Diagnosis Procedure
INFOID:0000000000904271
1.
CHECK IPDM E/R
CONSULT-III DATA MONITOR
1.
Turn the lighting switch 2ND.
2.
Select "HL WASHER REQ" of IPDM E/R data monitor item.
3.
Operate the headlamp washer.
4.
Check the status of "HL WASHER REQ".
Is the status of item normal?
YES
>> Refer to
WW-39, "Component Function Check"
NO
>> GO TO 2.
2.
CHECK COMBINATION SWITCH
1.
Perform the inspection of the combination switch. Refer to
Is combination switch normal?
YES
>> Replace BCM. Refer to
.
NO
>> Repair or replace the applicable parts.
Monitor item
Condition
Monitor
status
HL WASHER REQ
Headlamp washer
Operat-
ing
ON
Stopped
OFF
WW-96
< PRECAUTION >
PRECAUTIONS
PRECAUTION
PRECAUTIONS
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT
PRE-TENSIONER"
INFOID:0000000001102412
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain
types of collision. This system includes seat belt switch inputs and dual stage front air bag modules. The SRS
system uses the seat belt switches to determine the front air bag deployment, and may only deploy one front
air bag, depending on the severity of a collision and whether the front occupants are belted or unbelted.
Information necessary to service the system safely is included in the SRC and SB section of this Service Man-
ual.
WARNING:
• To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in
the event of a collision which would result in air bag inflation, all maintenance must be performed by
an authorized NISSAN/INFINITI dealer.
• Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal
injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag
Module, see the SRC section.
• Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this
Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or har-
ness connectors.
Precaution for Procedure without Cowl Top Cover
INFOID:0000000001102413
When performing the procedure after removing cowl top cover, cover
the lower end of windshield with urethane, etc.
PIIB3706J
HEADLAMP WASHER NOZZLE AND TUBE
WW-97
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
ON-VEHICLE REPAIR
HEADLAMP WASHER NOZZLE AND TUBE
Exploded View
INFOID:0000000000926336
Hydraulic Layout
INFOID:0000000000926340
Removal and Installation
INFOID:0000000000926337
REMOVAL
1.
Remove the front bumper fascia. Refer to
2.
Remove headlamp washer tube from headlamp washer nozzle assembly.
1.
Headlamp washer nozzle cover
2.
Headlamp washer nozzle assembly
A.
Pawl
JPLIA0293ZZ
1.
Headlamp washer nozzle assembly
(LH)
2.
Headlamp washer tube
3.
Headlamp washer tube joint
4.
Headlamp washer nozzle assembly
(RH)
: Clip
JPLIA0292ZZ
WW-98
< ON-VEHICLE REPAIR >
HEADLAMP WASHER NOZZLE AND TUBE
3.
Push pawl (A), and remove headlamp washer nozzle cover (1).
4.
Push pawl, and remove headlamp washer nozzle assembly from the front bumper fascia.
INSTALLATION
Note the following, and install in the reverse order of removal.
Inspection
INFOID:0000000000906858
HEADLAMP WASHER NOZZLE SPLAY POSITION INSPECTION
Check that the headlamp washer injection is certainly on the headlamp (LO) illuminating area. If the injection is
out of the area, check the headlamp washer tube and headlamp washer nozzle leakages.
: Vehicle front
JPLIA0294ZZ
JPLIA0295ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст