Nissan Qashqai (2007-2010). Manual — part 1199
FUEL FILLER LID OPENER
DLK-875
< ON-VEHICLE REPAIR >
[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
FUEL FILLER OPENER CABLE : Exploded View
INFOID:0000000001098813
FUEL FILLER OPENER CABLE : Removal and Installation
INFOID:0000000001098814
REMOVAL
1.
Remove the rear seat cushion, rear seatback, seatback lower support, and seatback mounting outer
bracket. Refer to
SE-31, "Removal and Installation"
2.
Remove the dash side finisher, front kicking plate inner, rear kicking plate inner, center pillar lower gar-
nish, and luggage side lower finisher (front). Refer to
INT-14, "Removal and Installation"
3.
Remove the parcel shelf, luggage floor carpet, luggage floor spacer, luggage rear plate, luggage side
lower finisher, and rear pillar finisher. Refer to
INT-24, "Removal and Installation"
4.
Remove the fuel filler lock seal (1).
1.
Fuel filler lid assembly
2.
Fuel filler opener cable
3.
Fuel opener lever
: Clip
JMKIA0187ZZ
JMKIA0182ZZ
DLK-876
< ON-VEHICLE REPAIR >
[WITHOUT I-KEY, WITH SUPER LOCK]
FUEL FILLER LID OPENER
5.
Rotate the fuel filler lock, and then remove the fuel filler lock.
6.
Remove the fuel filler opener cable mounting clips and the clamps.
7.
Remove the mounting bolts, and then remove the fuel filler lid
opener lever.
8.
Remove the fuel filler opener cable.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Check the fuel filler lid open/close operation after installation.
PIIB7988J
JMKIA0183ZZ
DOOR SWITCH
DLK-877
< ON-VEHICLE REPAIR >
[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
DOOR SWITCH
Exploded View
INFOID:0000000001095599
DLK-877, "Removal and Installation"
Removal and Installation
INFOID:0000000001095600
REMOVAL
1.
Remove the door switch mounting bolt (A), and then remove
door switch (1).
NOTE:
The same procedure is also performed for door switch (passen-
ger side, rear LH and rear RH).
INSTALLATION
Install in the reverse order of removal.
JMKIA0451ZZ
1.
Door switch (driver side)
JMKIA0452ZZ
DLK-878
< ON-VEHICLE REPAIR >
[WITHOUT I-KEY, WITH SUPER LOCK]
BACK DOOR OPENER SWITCH
BACK DOOR OPENER SWITCH
Exploded View
INFOID:0000000001116794
DLK-878, "Removal and Installation"
Removal and Installation
INFOID:0000000001116795
REMOVAL
1.
Remove the back door finisher.
Refer to
EXT-31, "Removal and Installation"
2.
Remove the back door opener switch (1) from back door finisher
(2) using flat-bladed screw driver (A) etc.
INSTALLATION
Install in the reverse order of removal.
JMKIA0516ZZ
1.
Back door opener switch
2.
Back door finisher
JMKIA0519ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст