Nissan Qashqai (2007-2010). Manual — part 1198
REAR DOOR LOCK
DLK-871
< ON-VEHICLE REPAIR >
[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
5.
Remove the door side grommet, and remove the door key cylin-
der assembly (driver side) and the outside handle escutcheon
(passenger side) mounting bolts from the grommet hole.
CAUTION:
Do not forcibly remove the bolts (TORX: T10).
6.
While pulling the outside handle, and then remove the door key
cylinder assembly.
7.
While pulling the outside handle, slide toward rear of vehicle to
remove the outside handle.
8.
Remove the front gasket and the rear gasket.
9.
While pulling the outside handle bracket, slide toward rear of
vehicle to remove the outside handle bracket.
JMKIA0020ZZ
PIIB5809E
PIIB5810E
PIIB5811E
PIIB5814E
DLK-872
< ON-VEHICLE REPAIR >
[WITHOUT I-KEY, WITH SUPER LOCK]
REAR DOOR LOCK
10. Reach in to separate the outside handle cable connection.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
• Check the door lock/unlock operation after installation.
• Check the door open/close operation after installation.
PIIB5815E
BACK DOOR LOCK
DLK-873
< ON-VEHICLE REPAIR >
[WITHOUT I-KEY, WITH SUPER LOCK]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
BACK DOOR LOCK
DOOR LOCK
DOOR LOCK : Exploded View
INFOID:0000000001098805
DOOR LOCK : Removal and Installation
INFOID:0000000001098806
REMOVAL
1.
Remove the back door trim finisher lower. Refer to
INT-26, "Removal and Installation"
.
2.
Disconnect the back door lock assembly and back door opener switch connectors.
3.
Remove the back door lock mounting bolts, and then remove the back door lock and actuator.
INSTALLTION
Install in the reverse order of removal.
CAUTION:
Check the back door lock/unlock operation after installation.
1.
Back door hinge
2.
Back door assembly
3.
Back door lock assembly
4.
Bumper rubber bracket
5.
Back door stay bracket (lower)
6.
Bumper rubber
7.
Back door stay
8.
Back door stay bracket (upper)
9.
Back door striker
Refer to
JMKIA0186ZZ
DLK-874
< ON-VEHICLE REPAIR >
[WITHOUT I-KEY, WITH SUPER LOCK]
FUEL FILLER LID OPENER
FUEL FILLER LID OPENER
FUEL FILLER LID
FUEL FILLER LID : Exploded View
INFOID:0000000001098811
FUEL FILLER LID : Removal and Installation
INFOID:0000000001098812
REMOVAL
1.
Fully open the fuel filler lid.
2.
Remove the filler cap.
3.
Remove the mounting screws (A), and then remove the fuel filler
lid (1).
INSTALLATION
Install in the reverse order of removal.
CAUTION:
After installation, apply the touch-up paint (the body color) onto the head of the mounting screws.
FUEL FILLER OPENER CABLE
1.
Fuel filler lid assembly
2.
Fuel filler opener cable
3.
Fuel opener lever
: Clip
JMKIA0187ZZ
JMKIA0181ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст