Nissan Qashqai (2007-2010). Manual — part 81
EM-272
< ON-VEHICLE REPAIR >
[K9K]
TURBOCHARGER
INSPECTION AFTER REMOVAL
CAUTION:
When the compressor wheel turbine wheel or rotor shaft is damaged, remove all the fragments and
foreign matter left in the following passages in order to prevent a secondary failure:
MBIB1419E
Suction side
: Between turbocharger and air cleaner
Exhaust side
: Between turbocharger and catalyst
EXHAUST MANIFOLD
EM-273
< ON-VEHICLE REPAIR >
[K9K]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
EXHAUST MANIFOLD
Exploded View
INFOID:0000000001060436
Removal and Installation
INFOID:0000000001060437
REMOVAL
1.
Remove battery ground cable.
2.
Remove engine undercover.
3.
Remove air cleaner case and air duct (inlet). Refer to
EM-265, "Removal and Installation"
.
4.
Remove wiper assembly.
5.
Remove bulk head cover.
6.
Remove EGR unit assembly. Refer to
EM-268, "Removal and Installation"
.
7.
Remove turbocharger assembly. Refer to
EM-271, "Removal and Installation"
8.
Loosen exhaust manifold mounting nuts in the reverse order as
shown. Then remove exhaust manifold.
CAUTION:
Be careful not to deform each turbocharger piping when pulling
out the assembly.
INSTALLATION
1.
Clean the surface of exhaust manifold and cylinder head.
2.
Install new gasket to cylinder head.
1.
Gasket
2.
Exhaust manifold
A.
To cylinder head
Refer to
E1BIA0002GB
MBIB1417E
EM-274
< ON-VEHICLE REPAIR >
[K9K]
EXHAUST MANIFOLD
3.
Tighten the mounting nuts in numerical order as shown.
4.
Install in reverse order of removal after this step.
Inspection
INFOID:0000000001060438
INSPECTION AFTER INSTALLATION
Start engine and raise engine speed to check no exhaust emission leaks.
: 26.0 N·m (2.7 kg-m, 19 ft-lb)
MBIB1417E
GLOW PLUG
EM-275
< ON-VEHICLE REPAIR >
[K9K]
C
D
E
F
G
H
I
J
K
L
M
A
EM
N
P
O
GLOW PLUG
Exploded View
INFOID:0000000001060276
Removal and Installation
INFOID:0000000001060439
REMOVAL
CAUTION:
Remove glow plug only if necessary. If carbon adheres, it may be stuck and broken.
1.
Disconnect battery ground cable.
2.
Remove engine cover. Refer to
EM-266, "Removal and Installation"
.
3.
Disconnect harness connector from glow plug.
4.
Remove glow plug.
CAUTION:
• When removing or installing, do not use such tools as an air impact wrench.
• Handle it carefully without giving any impact, even after removal. [As a guide, if it drops from
height of 10 cm (3.94 in) or higher, always replace it.]
INSTALLATION
1.
Remove adhered carbon from glow plug installation hole with a reamer.
2.
Install glow plug.
3.
Install remaining parts in reverse order of removal.
1.
Glow plug
: Engine front
Refer to
E1BIA0005GB
: 15.0 N·m (1.5 kg-m, 11 ft-lb)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст