Nissan Qashqai (2007-2010). Manual — part 598
CONTROL DEVICE
TM-327
< ON-VEHICLE REPAIR >
[CVT: RE0F10A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
7.
Disconnect CVT device harness connector (A).
8.
Move selector lever to “P” position.
9.
Disconnect key interlock cable (1) from control device assembly.
10. Disconnect control cable (2) from control device assembly.
11. Remove control device assembly.
12. Remove position lamp.
13. Unhook (
) position indicator plate (1) for removal.
JPDIA0075ZZ
JPDIA0074ZZ
: Bolt
JPDIA0079ZZ
TM-328
< ON-VEHICLE REPAIR >
[CVT: RE0F10A]
CONTROL DEVICE
• LHD
• RHD
INSTALLATION
Note the following, and install in the reverse order of removal.
A
: Driver side
B
: Passenger side
JPDIA0316ZZ
A
: Passenger side
B
: Driver side
JPDIA0317ZZ
CONTROL DEVICE
TM-329
< ON-VEHICLE REPAIR >
[CVT: RE0F10A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
• When installing the control cable (1) to the control device assembly
(2), make sure that the control cable is fully pressed in with the
ribbed (A) surface facing upward.
Inspection and Adjustment
INFOID:0000000000914713
ADJUSTMENT AFTER INSTALLATION
Adjust the CVT positions after installing the control device. Refer to
TM-324, "Inspection and Adjustment"
.
INSPECTION AFTER INSTALLATION
Check the CVT positions after adjusting the CVT positions. Refer to
TM-324, "Inspection and Adjustment"
JPDIA0078ZZ
TM-330
< ON-VEHICLE REPAIR >
[CVT: RE0F10A]
CONTROL CABLE
CONTROL CABLE
Exploded View
INFOID:0000000000914714
Removal and Installation
INFOID:0000000000914715
REMOVAL
CAUTION:
Make sure that parking brake is applied before removal/installation.
1.
Disconnect control cable from control device assembly. Refer to
.
2.
Move selector lever to “P” position.
3.
Remove the air cleaner assembly. Refer to
.
4.
Remove nut (A) and control cable (1) from the manual lever (B).
5.
Remove the lock plate (2) and the control cable from the bracket
(3).
6.
Remove exhaust front tube. Refer to
7.
Separate the propeller shaft. Refer to
(4WD only).
8.
Remove heat plate.
1.
Control cable
2.
Lock plate
3.
Bracket
4.
Transaxle assembly
5.
Bracket
6.
Control device assembly
A.
Manual lever
Refer to
for symbols in the figure.
JPDIA0076GB
JPDIA0106ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст