Nissan Sentra. Instruction — part 139

BCS-126

< REMOVAL AND INSTALLATION >

[WITHOUT INTELLIGENT KEY SYSTEM]

BCM (BODY CONTROL MODULE)

REMOVAL AND INSTALLATION

BCM (BODY CONTROL MODULE)

Removal and Installation

INFOID:0000000009757400

NOTE:

Before replacing BCM, perform “READ CONFIGURATION” to save or print current vehicle specification. Refer

BCS-116, "CONFIGURATION (BCM) : Description"

REMOVAL

1. Disconnect the negative battery terminal. Refer to

PG-52, "Removal and Installation"

2. Remove instrument lower panel LH and instrument side finisher LH. Refer to

IP-21, "Removal and Instal-

lation"

3. Remove fuse block (J/B) screws (A) and position (BCM) aside.

4. Remove harness clip (A).

5. Remove the screws (A) from the BCM (1).

6. Disconnect the harness connectors and remove the BCM.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

• Perform “CONFIGURATION (BCM)” when replacing BCM. Refer to

BCS-116, "CONFIGURATION

(BCM) : Description"

JMMIA1224ZZ

JMMIA1225ZZ

JMMIA1226ZZ

BCS

BCM (BODY CONTROL MODULE)

BCS-127

< REMOVAL AND INSTALLATION >

[WITHOUT INTELLIGENT KEY SYSTEM]

• Be sure to perform the system initialization (NATS) when replacing BCM. Refer to

BCS-115, "ADDI-

TIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Work Procedure"

• When replacing BCM, if new BCM does not come with keyfobs attached, all existing keyfobs must be

re-registered.

BCS-128

< REMOVAL AND INSTALLATION >

[WITHOUT INTELLIGENT KEY SYSTEM]

COMBINATION SWITCH

COMBINATION SWITCH

Exploded View

INFOID:0000000009757401

NOTE:

Shown with the steering wheel removed for clarity only.

Removal and Installation

INFOID:0000000009757402

REMOVAL

CAUTION:

• Before servicing, turn the ignition switch OFF, disconnect both battery terminals and wait at least

three minutes.

• Do not use air or electric tools when removing or installing the combination switch.
1. Disconnect both the negative and positive battery terminals, then wait at least three minutes. Refer to

PG-

50, "Removal and Installation (Battery)"

2. Remove the steering column covers. Refer to

IP-16, "Removal and Installation"

3. Rotate steering wheel clockwise to access first combination switch bolt and remove.
4. Rotate steering wheel counter-clockwise to access second combination switch bolt and remove.
5. Disconnect the harness connector from the combination switch and remove.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:

• After the work is completed, make sure no system malfunction is detected by air bag warning lamp.

• In case a malfunction is detected by the air bag warning lamp, reset with the self-diagnosis function

and delete the memory with CONSULT.

• If a malfunction is still detected after the above operation, perform self-diagnosis to repair malfunc-

tions. Refer to

SRC-41, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair

Requirement"

AWMIA1293ZZ

Combination switch