Nissan Sentra. Instruction — part 319
DMS-48
< WIRING DIAGRAM >
[SPORT MODE (M/T)]
SPORT MODE SYSTEM
ABOIA0169GB
DMS
SPORT MODE SYSTEM
DMS-49
< WIRING DIAGRAM >
[SPORT MODE (M/T)]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
ABOIA0170GB
DMS-50
< BASIC INSPECTION >
[SPORT MODE (M/T)]
DIAGNOSIS AND REPAIR WORK FLOW
BASIC INSPECTION
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
INFOID:0000000009755928
OVERALL SEQUENCE
DETAILED FLOW
JSCIA0443GB
DMS
DIAGNOSIS AND REPAIR WORK FLOW
DMS-51
< BASIC INSPECTION >
[SPORT MODE (M/T)]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
1.
GET INFORMATION FOR SYMPTOM
Get the detailed information from the customer about the symptom (the condition and the environment when
the incident/malfunction occurred) using the “Diagnostic Work Sheet”. (Refer to
>> GO TO 2.
2.
CHECK DTC IN ECM
1. Check DTC in ECM.
2. If a DTC is detected, perform the following steps, and after this, erase DTC.
-
Print (or write down) the detected DTC and freeze frame data.
-
Check DTC logic.
-
Study the relationship between the cause detected by DTC and the symptom described by the customer.
3. Check related Service Bulletins.
Are any symptoms described and any DTCs detected?
Symptom is described, DTC is detected>>GO TO 3.
Symptom is described, DTC is not detected>>GO TO 4.
Symptom is not described, DTC is detected>>GO TO 5.
3.
CONFIRM THE SYMPTOM
Try to confirm the symptom described by the customer.
Also study the normal operation and fail-safe related to the symptom. Refer to
and
Diagnosis Work Sheet is useful to verify the incident.
Verify relation between the symptom and the condition when the symptom is detected.
>> GO TO 5.
4.
CONFIRM THE SYMPTOM
Try to confirm the symptom described by the customer.
Verify relation between the symptom and the condition when the symptom is detected.
>> GO TO 6.
5.
PERFORM DTC CONFIRMATION PROCEDURE
Perform DTC CONFIRMATION PROCEDURE for the displayed DTC, and then check that DTC is detected
again.
If two or more DTCs are detected, refer to
EC-93, "DTC Inspection Priority Chart"
and determine trouble
diagnosis order.
NOTE:
• Freeze frame data is useful if the DTC is not detected.
• Perform Component Function Check if DTC CONFIRMATION PROCEDURE is not included on Service
Instruction. This simplified check procedure is an effective alternative though DTC cannot be detected during
this check.
If the result of Component Function Check is NG, it is the same as the detection of DTC by DTC CONFIR-
MATION PROCEDURE.
Is DTC detected?
YES
>> GO TO 7.
NO
>> Check SPORT mode system. Refer to
DMS-57, "Component Function Check"
6.
DETECT MALFUNCTIONING PART BY SYMPTOM DIAGNOSIS
Detect malfunctioning system according to Symptom Diagnosis based on the confirmed symptom in step 4,
and determine the trouble diagnosis order based on possible causes and symptoms.
Is the symptom described?
YES
>> GO TO 7.
NO
>> Monitor input data from related sensors or check voltage of related ECM terminals using CON-
SULT. Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст