Nissan Quest E52. Instruction — part 1237
TM-178
< UNIT DISASSEMBLY AND ASSEMBLY >
[CVT: RE0F09B]
TORQUE CONVERTER
• Attach the pawl (A) of the torque converter to the inner gear hole
(B) on the oil pump side.
CAUTION:
• Rotate the torque converter for installing torque converter.
• Never damage bushing inside of torque converter sleeve
when removing torque converter.
Inspection
INFOID:0000000009650258
INSPECTION AFTER INSTALLATION
After inserting a torque converter to transaxle assembly, check
dimension (A) is within the reference value limit.
JPDIA0692ZZ
B
: Scale
C
: Straightedge
Dimension A
: Refer to
.
JPDIA0620ZZ
SERVICE DATA AND SPECIFICATIONS (SDS)
TM-179
< SERVICE DATA AND SPECIFICATIONS (SDS)
[CVT: RE0F09B]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
General Specification
INFOID:0000000009650259
Vehicle Speed When Shifting Gears
INFOID:0000000009650260
Numerical value data are reference values.
Unit: rpm
CAUTION:
Lock-up clutch is engaged when vehicle speed is approximately 18 km/h (11 MPH) to 90 km/h (56 MPH).
Stall Speed
INFOID:0000000009650261
Line Pressure
INFOID:0000000009650262
Unit: kPa (kg/cm
2
, psi)
Torque Converter
INFOID:0000000009650263
Heater Thermostat
INFOID:0000000009650264
Standard
Applied model
Engine
VQ35DE
Axle
2WD
CVT model
RE0F09B
Transmission gear ratio
“D” position
2.371 – 0.439
Reverse
1.766
Final drive
4.878
Recommended fluid and fluid capaciry
MA-10, "Fluids and Lubricants"
.
Throttle position
Shift pattern
Engine speed
At 40 km/h (25 MPH)
At 60 km/h (37 MPH)
8/8
“D” position
3,100 – 4,000
4,200 – 5,100
Overdrive OFF condition
3,100 – 4,000
4,200 – 5,100
“L” position
3,100 – 4,000
4,200 – 5,100
2/8
“D” position
1,100 – 3,000
1,200 – 3,400
Overdrive OFF condition
2,200 – 3,000
2,800 – 3,600
“L” position
2,700 – 3,600
3,600 – 4,500
Stall speed
2,700 – 3,250 rpm
Engine speed
Line pressure
“R”, “D” and “L” positions
At idle
700 (7.14, 101.5)
At stall
5,700 (58.14, 826.5)
Dimension between end of converter housing and torque converter
14.0 mm (0.55 in)
Valve opening temperature
71
°
C (159
°
F)
TM-180
< SERVICE DATA AND SPECIFICATIONS (SDS)
[CVT: RE0F09B]
SERVICE DATA AND SPECIFICATIONS (SDS)
Maximum valve lift
5.0 mm / 85
°
C (0.197 in / 185
°
F)
Valve closing temperature
65
°
C (149
°
F)
VTL-1
VENTILATION, HEATER & AIR CONDITIONER
C
D
E
F
G
H
J
K
L
M
SECTION
VTL
A
B
VTL
N
O
P
CONTENTS
VENTILATION SYSTEM
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
Precaution for Procedure without Cowl Top Cover
. ..
Precautions for Removing Battery Terminal . . .....
PREPARATION . . . . . . . . . . .
PREPARATION . . . . . . . . . . . . ...
Commercial Service Tool . . . . . . . . . . ..
SYSTEM DESCRIPTION . . . . . . . ..
VENTILATION SYSTEM . . . . . . . . . .
VENTILATION SYSTEM (FRONT AIR CONDI-
TIONING) . . . . . . . . . . . . . . . . .....
VENTILATION SYSTEM (FRONT AIR CONDI-
TIONING) : System Description . . . . . . . ....
VENTILATION SYSTEM (REAR AIR CONDITION-
ING) . . . . . . . . . . . . . . . . . . . ..
VENTILATION SYSTEM (REAR AIR CONDI-
TIONING) : System Description . . . . . . . ....
REMOVAL AND INSTALLATION . . . .
DUCT AND GRILLE . . . . . . . . . . .
Exploded View . . . . . . . . . . . . . . ..
CENTER VENTILATOR GRILLE . . . . . . . ....
CENTER VENTILATOR GRILLE : Removal and
Installation . . . . . . . . . . . . . . . .....
SIDE VENTILATOR GRILLE . . . . . . . . . .
SIDE VENTILATOR GRILLE : Removal and In-
stallation . . . . . . . . . . . . . . . . ..
SIDE DEFROSTER GRILLE . . . . . . . . . .
SIDE DEFROSTER GRILLE : Removal and In-
stallation . . . . . . . . . . . . . . . . ..
CENTER VENTILATOR DUCT . . . . . . . . ..
CENTER VENTILATOR DUCT : Removal and In-
stallation . . . . . . . . . . . . . . . . ..
FRONT DEFROSTER NOZZLE . . . . . . . . .
FRONT DEFROSTER NOZZLE : Removal and In-
stallation . . . . . . . . . . . . . . . . ..
SIDE DEFROSTER NOZZLE . . . . . . . . . .
SIDE DEFROSTER NOZZLE : Removal and In-
stallation . . . . . . . . . . . . . . . . ..
FRONT FLOOR DUCT 1 . . . . . . . . . . .
FRONT FLOOR DUCT 1 : Removal and Installa-
tion . . . . . . . . . . . . . . . . . . ...
FRONT FLOOR DUCT 2 . . . . . . . . . . .
FRONT FLOOR DUCT 2 : Removal and Installa-
tion . . . . . . . . . . . . . . . . . . ...
FOOT DUCT . . . . . . . . . . . . . . . ...
FOOT DUCT : Removal and Installation . . . . .
REAR VENTILATOR GRILLE . . . . . . . . ...
REAR VENTILATOR GRILLE : Removal and In-
stallation . . . . . . . . . . . . . . . . ..
REAR FOOT DUCT . . . . . . . . . . . . ...
REAR FOOT DUCT : Removal and Installation . ..
REAR VENTILATOR DUCT . . . . . . . . . ..
REAR VENTILATOR DUCT : Removal and Instal-
lation . . . . . . . . . . . . . . . . . .
BLOWER UNIT . . . . . . . . . . . . .
Exploded View . . . . . . . . . . . . . . .
Removal and Installation . . . . . . . . . . .
BLOWER MOTOR . . . . . . . . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст