Nissan Quest E52. Instruction — part 59
AV
SLIDE DOOR SPEAKER
AV-115
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
SLIDE DOOR SPEAKER
Removal and Installation
INFOID:0000000009651970
REMOVAL
1.
Remove slide door finisher. Refer to
INT-17, "Removal and Installation"
2.
Remove screws and disconnect connector, and remove slide door speaker.
INSTALLATION
Install in the reverse order of removal.
AV-116
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
REAR VIEW CAMERA
REAR VIEW CAMERA
Removal and Installation
INFOID:0000000009943033
REMOVAL
1.
Remove back door finisher. Refer to
EXT-47, "Removal and Installation"
2.
Remove screws to remove rear view camera from back door finisher.
INSTALLATION
Install in the reverse order of removal.
NOTE:
Adjust the guide line position if the guide line position is shifted after installing the rear view camera. Refer to
Adjustment
INFOID:0000000009651972
Adjust the guide line position if the guide line position is shifted after installing the rear view camera.
1.
Draw lines on rearward area of the vehicle passing through the
following points: 200 mm (7.87 in) from both sides of the vehicle,
and 0.5 m (1.64 ft), 1.0 m (3.28 ft) from the rear end of the
bumper.
2.
Set into “Camera system” mode of Confirmation / Adjustment
mode.
3.
Press “1” or “2” switches, and then select the guiding line pattern
so that its angle is aligned with the correction line of the rear of
the vehicle.
4.
Make fine adjustment to the correction line of the rear of the
vehicle with “3”, “4”, “5” or “6” switches so that its position is
aligned with the guiding line. Press “PUSH ENTER” switch and
record the adjusted guiding line position to the camera control
unit.
CAUTION:
Never operate other function such as pressing BACK while writing index data.
SKIB3691E
Selected pattern
: 7
Up/Down adjustment range
: (
−
20) – (20)
Left/Right adjustment range
: (
−
20) – (20)
JSNIA1876ZZ
AV
USB CONNECTOR
AV-117
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
USB CONNECTOR
Removal and Installation
INFOID:0000000009651973
REMOVAL
1.
Remove center console upper finisher. Refer to
IP-29, "Disassembly and Assembly"
2.
Unhook pawl to remove USB connector from center console upper finisher.
INSTALLATION
Install in the reverse order of removal.
AV-118
< REMOVAL AND INSTALLATION >
[DISPLAY AUDIO]
TEL ADAPTER UNIT
TEL ADAPTER UNIT
Removal and Installation
INFOID:0000000009651974
REMOVAL
1.
Remove cluster lid C. Refer to
IP-14, "Removal and Installation"
2.
Remove TEL adapter unit mounting bracket screws.
3.
Disconnect connector to remove TEL adapter unit, TEL antenna, and bracket as a single unit.
4.
Remove bracket screws to remove TEL adapter unit from bracket.
INSTALLATION
Install in the reverse order of removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст