Nissan Quest E52. Instruction — part 1026
SQUEAK AND RATTLE TROUBLE DIAGNOSES
RF-47
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
PIIB8742E
RF-48
< REMOVAL AND INSTALLATION >
GLASS LID
REMOVAL AND INSTALLATION
GLASS LID
FRONT SUNROOF
FRONT SUNROOF : Exploded View
INFOID:0000000009650386
FRONT SUNROOF : Removal and Installation
INFOID:0000000009650387
REMOVAL
1.
Glass lid
2.
TORX bolt
3.
Front sunroof bracket
4.
Center drain hose
5.
Side trim
6.
Front drain hose
7.
Front drain connector
8.
Sunroof motor assembly
9.
Sunroof unit assembly
: Metal clip
,
: Indicates that the part is connected at points with same symbol in actual vehicle.
JMKIA6143ZZ
GLASS LID
RF-49
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
RF
N
O
P
1.
Tilt up glass lid and remove side trims (LH and RH).
2.
Remove glass lid mounting TORX bolts, and then remove glass lid from vehicle.
3.
Fully close glass lid.
INSTALLAITON
Note the following items, and then install in the reverse order of removal.
NOTE:
After installation carry out fitting adjustment. Refer to
RF-49, "FRONT SUNROOF : Adjustment"
FRONT SUNROOF : Adjustment
INFOID:0000000009650388
Adjustment
If the clearance and the surface height are out of specification, adjust them according to the procedures shown below.
1.
Tilt up glass lid and remove side trims (LH and RH).
2.
Loosen glass lid mounting TORX bolts.
3.
Adjust the clearance of glass lid and roof panel according to the fitting standard dimension.
1.
Roof panel
2.
Glass lid
JMKIA6146ZZ
Portion
a (Clearance)
b (Surface height difference)
A – A
6.5 – 8.1 mm
(0.256 – 0.319 in)
(
−
2.3) – (+0.7) mm
[(
−
0.091) – (+0.028) in]
B – B
6.5 – 8.1 mm
(0.256 – 0.319 in)
(
−
2.3) – (+0.7) mm
[(
−
0.091) – (+0.028) in]
C – C
6.5 – 8.1 mm
(0.256 – 0.319 in)
(
−
2.3) – (+0.7) mm
[(
−
0.091) – (+0.028) in]
RF-50
< REMOVAL AND INSTALLATION >
GLASS LID
4.
To prevent glass lid from moving after adjustment, first tighten the TORX bolts of front left, and then
tighten the TORX bolts of rear right.
5.
Tilt glass lid up and down several times to check that it moves smoothly.
NOTE:
After adjustment the sunroof unit assembly, perform additional service. Refer to
.
REAR SUNROOF
REAR SUNROOF : Exploded View
INFOID:0000000009650389
1.
Glass lid
2.
TORX bolt
3.
Side trim
4.
Rear sunroof bracket
5.
Rear drain hose
6.
Rear drain connector
7.
Rear display bracket
8.
Sunroof motor assembly
9.
Sunroof unit assembly
: Indicates that the part is connected at points with same symbol in actual vehicle.
JMKIA6144ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст