Nissan Quest E52. Instruction — part 293
DAS-14
< SYSTEM DESCRIPTION >
[BSW]
SYSTEM
Fail-safe (Side Radar)
INFOID:0000000009940669
FAIL-SAFE CONTROL BY DTC
If a malfunction occurs in the side radar, BSW control module cancels the control. Then the BSW warning
lamp in the combination meter illuminates.
TEMPORARY DISABLED STATUS AT BLOCKAGE
When the side radar is blocked, the operation is temporarily cancelled. Then BSW warning lamp in combina-
tion meter blinks. Also, under the following conditions, the operation may be temporarily cancelled.
• The side radar may be blocked by temporary ambient conditions such as splashing water, mist or fog.
• The blocked condition may also be caused by objects such as ice, frost or dirt obstructing the side radar.
DAS
OPERATION
DAS-15
< SYSTEM DESCRIPTION >
[BSW]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
OPERATION
Switch Name and Function
INFOID:0000000009940670
System Display and Warning
INFOID:0000000009940671
INDICATOR AND WARNING LAMP
DISPLAY AND WARNING OPERATION
JSOIA0507ZZ
No.
Name
Function
1
BSW switch
Turns BSW system ON/OFF
JSOIA0508ZZ
No.
Name
Description
1
BSW ON indicator
Turns ON while BSW system is ON
2
BSW warning lamp
(In the combination meter)
• Turns ON when BSW system is malfunctioning
• Blinks when radar blockage is detected
Vehicle condition/ Driver's operation
Action
BSW ON
indicator
Vehicle speed
(Approx.)
[km/h (MPH)]
Turn signal
condition
Status of ve-
hicle detec-
tion within
detection
area
Indication on the
BSW indicator
Buzzer
OFF
—
—
—
OFF
OFF
DAS-16
< SYSTEM DESCRIPTION >
[BSW]
OPERATION
NOTE:
• If vehicle speed exceeds approximately 32 km/h (20MPH), BSW function operates until the vehicle speed
becomes lower than approximately 29km/h (18MPH).
• Time shown in the figure is approximate time.
ON
Less than ap-
prox.
29 (18)
—
—
OFF
OFF
Approx.
32 (20)
or more
—
Vehicle is
absent
OFF
OFF
OFF
Vehicle is
detected
ON
OFF
ON
(Vehicle de-
tected direc-
tion)
Before turn
signal oper-
ates
Vehicle is
detected
Blink
Short continuous beep
Vehicle is
detected af-
ter turn sig-
nal operates
Blink
OFF
Vehicle condition/ Driver's operation
Action
BSW ON
indicator
Vehicle speed
(Approx.)
[km/h (MPH)]
Turn signal
condition
Status of ve-
hicle detec-
tion within
detection
area
Indication on the
BSW indicator
Buzzer
JSOIA0251GB
JSOIA0452GB
JSOIA0251GB
DAS
HANDLING PRECAUTION
DAS-17
< SYSTEM DESCRIPTION >
[BSW]
C
D
E
F
G
H
I
J
K
L
M
B
N
P
A
HANDLING PRECAUTION
Precautions for Blind Spot Warning
INFOID:0000000009940672
SIDE RADAR HANDLING
• Side radar for BSW system is located inside the rear bumper.
• Always keep the rear bumper near the side radar clean.
• Do not attach a sticker (including transparent material), install an accessory or paintwork near the side radar.
• Do not strike or damage the areas around the side radar.
• Do not strike, damage, and scratch the side radar, especially the vent seal (gray circular) area, under repair.
PRECAUTIONS FOR BLIND SPOT WARNING
• The BSW system is not a replacement for proper driving procedure and are not designed to prevent contact
with vehicles or objects. When changing lanes, always use the side and rear mirrors and turn and look in the
direction driver will move to ensure it is safe to change lanes. Never rely solely on the BSW system.
• The BSW system may not provide a warning for vehicles that pass through the detection zone quickly.
• Do not use the BSW system when towing a trailer because the system may not function properly.
• Excessive noise (e.g. audio system volume, open vehicle window) will interfere with the chime sound, and it
may not be heard.
• The side radar may not be able to detect and activate BSW when certain objects are present such as:
- Pedestrians, bicycles, animals.
- Several types of vehicles such as motorcycles.
- Oncoming vehicles.
- Vehicles remaining in the detection zone when driver accelerate from a stop.
- A vehicle merging into an adjacent lane at a speed approximately the same as vehicle.
- A vehicle approaching rapidly from behind.
- A vehicle which vehicle overtakes rapidly.
• Severe weather or road spray conditions may reduce the ability of the side radar to detect other vehicles.
• The side radar detection zone is designed based on a standard lane width. When driving in a wider lane, the
side radar may not detect vehicles in an adjacent lane. When driving in a narrow lane, the side radar may
detect vehicles driving two lanes away.
• The side radar are designed to ignore most stationary objects, however objects such as guardrails, walls,
foliage and parked vehicles may occasionally be detected. This is a normal operating condition.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст