Nissan Cube. Instruction — part 1030
DIAGNOSIS SYSTEM (BCM) (WITH INTELLIGENT KEY SYSTEM)
WT-11
< SYSTEM DESCRIPTION >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
WORK SUPPORT MODE
SELF-DIAG RESULTS MODE
DATA MONITOR MODE
Screen of data monitor mode is displayed.
NOTE:
• When malfunction is detected, CONSULT perform REAL-TIME DIAGNOSIS.
Also, any malfunction detected while in this mode will be displayed at real time.
• The following table includes information(items)inapplicable to this vehicle. For information(items)applicable
to this vehicle, refer to CONSULT display items.
NOTE:
Before performing the self-diagnosis, be sure to register the ID, or erase the actual malfunction location may
be different from that displayed on CONSULT.
ACTIVE TEST MODE
NOTE:
Before performing the self-diagnosis, be sure to register the ID, or erase the actual malfunction may be differ-
ent from that displayed on CONSULT.
TEST ITEM LIST
Diagnostic test mode
Function
Work support
In this mode, it is possible to make quick and accurate adjustments by following the instruc-
tions on the CONSULT display.
Self diagnostic result
Receives self-diagnosis results from the BCM, and indicates DTCs and the number of mal-
functions.
Data monitor
Receives input/output signals from the BCM and indicates and stores them to facilitate locating
the causes of malfunctions.
Active test
Transmits command to the BCM to change output signals and check operation of output sys-
tem.
Monitor item (Unit)
Remark
AIR PRESS FL (kPa), (kg/cm
2
), (Psi)
Air pressure of tires
AIR PRESS FR (kPa), (kg/cm
2
), (Psi)
AIR PRESS RR (kPa), (kg/cm
2
), (Psi)
AIR PRESS RL (kPa), (kg/cm
2
), (Psi)
ID REGST FL1
ID is registered: Done
ID is not registered: Yet
ID REGST FR1
ID REGST RR1
ID REGST RL1
WARNING LAMP
Low tire pressure warning lamp ON: On
Low tire pressure warning lamp OFF: Off
BUZZER
Combination meter buzzer ON: On
Combination meter buzzer OFF: Off
Test item
Content
WARNING LAMP
This test is able to check to check that the low tire pressure warning lamp turns on.
ID REGIST WARNING
This test is able to check to check that the buzzer sounds or the low tire pressure warning lamp
turns on.
RUN FLAT TIRE W/L
NOTE:
This item is displayed, but cannot be use this item.
WT-12
< SYSTEM DESCRIPTION >
DIAGNOSIS SYSTEM (BCM) (WITH INTELLIGENT KEY SYSTEM)
FLASHER
This test is able to check to check that each turn signal lamp turns on.
HORN
This test is able to check to check that the horn sounds.
Test item
Content
DIAGNOSIS SYSTEM (BCM) (WITHOUT INTELLIGENT KEY SYSTEM)
WT-13
< SYSTEM DESCRIPTION >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
DIAGNOSIS SYSTEM (BCM) (WITHOUT INTELLIGENT KEY SYSTEM)
COMMON ITEM
COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)
INFOID:0000000009949847
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functions for each system.
NOTE:
It can perform the diagnosis modes except the following for all sub system selection items.
×
: Applicable item
AIR PRESSURE MONITOR
AIR PRESSURE MONITOR : CONSULT Function
INFOID:0000000009949848
FUNCTION
Diagnosis mode
Function Description
Work Support
Changes the setting for each system function.
Self Diagnostic Result
Displays the diagnosis results judged by BCM.
CAN Diag Support Monitor
Monitors the reception status of CAN communication viewed from BCM.
Data Monitor
The BCM input/output signals are displayed.
Active Test
The signals used to activate each device are forcibly supplied from BCM.
Ecu Identification
The BCM part number is displayed.
Configuration
• Read and save the vehicle specification.
• Write the vehicle specification when replacing BCM.
System
Sub system selection item
Diagnosis mode
Work Support
Data Monitor
Active Test
Door lock
DOOR LOCK
×
×
×
Rear window defogger
REAR DEFOGGER
×
×
Warning chime
BUZZER
×
×
Interior room lamp control
INT LAMP
×
×
×
Remote keyless entry system
MULTI REMOTE ENT
×
×
×
Exterior lamp
HEAD LAMP
×
×
×
Wiper and washer
WIPER
×
×
×
Turn signal and hazard warning lamps
FLASHER
×
×
Instruction air conditioner
AIR CONDITONER
×
×
Combination switch
COMB SW
×
Body control system
BCM
×
NVIS - NATS
IMMU
×
×
×
Interior room lamp battery saver
BATTERY SAVER
×
×
×
Back door
TRUNK
×
Vehicle security system
THEFT ALM
×
×
×
RAP system
RETAINED PWR
×
×
Signal buffer system
SIGNAL BUFFER
×
×
TPMS
TPMS (AIR PRESSURE MONITOR)
×
×
×
Panic alarm system
PANIC ALARM
×
WT-14
< SYSTEM DESCRIPTION >
DIAGNOSIS SYSTEM (BCM) (WITHOUT INTELLIGENT KEY SYSTEM)
The diagnosis functions (main functions) include the following: “WORK SUPPORT”, “SELF DIAGNOSTIC
RESULT”, “DATA MONITOR” and “ACTIVE TEST”.
WORK SUPPORT MODE
SELF-DIAG RESULTS MODE
DATA MONITOR MODE
Screen of data monitor mode is displayed.
NOTE:
• When malfunction is detected, CONSULT perform REAL-TIME DIAGNOSIS.
Also, any malfunction detected while in this mode will be displayed at real time.
• The following table includes information(items)inapplicable to this vehicle. For information(items)applicable
to this vehicle, refer to CONSULT display items.
NOTE:
Before performing the self-diagnosis, be sure to register the ID, or erase the actual malfunction location may
be different from that displayed on CONSULT.
ACTIVE TEST MODE
NOTE:
Before performing the self-diagnosis, be sure to register the ID, or erase the actual malfunction may be differ-
ent from that displayed on CONSULT.
TEST ITEM LIST
Diagnostic test mode
Function
Work support
In this mode, it is possible to make quick and accurate adjustments by following the instruc-
tions on the CONSULT display.
Self diagnostic result
Receives self-diagnosis results from the BCM, and indicates DTCs and the number of mal-
functions.
Data monitor
Receives input/output signals from the BCM and indicates and stores them to facilitate locating
the causes of malfunctions.
Active test
Transmits command to the BCM to change output signals and check operation of output sys-
tem.
Monitor item (Unit)
Remark
AIR PRESS FL (kPa), (kg/cm
2
), (Psi)
Air pressure of tires
AIR PRESS FR (kPa), (kg/cm
2
), (Psi)
AIR PRESS RR (kPa), (kg/cm
2
), (Psi)
AIR PRESS RL (kPa), (kg/cm
2
), (Psi)
ID REGST FL1
ID is registered: Done
ID is not registered: Yet
ID REGST FR1
ID REGST RR1
ID REGST RL1
WARNING LAMP
Low tire pressure warning lamp ON: On
Low tire pressure warning lamp OFF: Off
BUZZER
Combination meter buzzer ON: On
Combination meter buzzer OFF: Off
Test item
Content
WARNING LAMP
This test is able to check to check that the low tire pressure warning lamp turns on.
ID REGIST WARNING
This test is able to check to check that the buzzer sounds or the low tire pressure warning lamp
turns on.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст