Nissan Cube. Instruction — part 492
FAX-4
< PRECAUTION >
PRECAUTIONS
Precautions for Removing of Battery Terminal
INFOID:0000000010078183
• When removing the 12V battery terminal, turn OFF the ignition
switch and wait at least 30 seconds.
NOTE:
ECU may be active for several tens of seconds after the ignition
switch is turned OFF. If the battery terminal is removed before ECU
stops, then a DTC detection error or ECU data corruption may
occur.
• For vehicles with the 2-batteries, be sure to connect the main bat-
tery and the sub battery before turning ON the ignition switch.
NOTE:
If the ignition switch is turned ON with any one of the terminals of
main battery and sub battery disconnected, then DTC may be
detected.
• After installing the 12V battery, always check "Self Diagnosis Result" of all ECUs and erase DTC.
NOTE:
The removal of 12V battery may cause a DTC detection error.
SEF289H
PREPARATION
FAX-5
< PREPARATION >
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000009948787
The actual shapes of Kent-More tools may differ from those of special service tools illustrated here.
Commercial Service Tool
INFOID:0000000009948788
Tool number
(Kent-More No.)
Tool name
Description
KV40107300
(
—
)
Boot band crimping tool
Installing boot band
KV40107500
(
—
)
Drive shaft attachment
Removing drive shaft
KV38107900
(
—
)
Protector
a: 32 mm (1.26 in) dia.
Installing drive shaft
ZZA1229D
ZZA1230D
PDIA1183J
Tool name
Description
Power tool
Loosening bolts and nuts
PBIC0190E
FAX-6
< PREPARATION >
PREPARATION
Drive shaft puller
Removing drive shaft joint sub assembly
Sliding hummer
Removing drive shaft
Tool name
Description
JPDIG0152ZZ
ZZA0023D
FRONT WHEEL HUB AND KNUCKLE
FAX-7
< PERIODIC MAINTENANCE >
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
PERIODIC MAINTENANCE
FRONT WHEEL HUB AND KNUCKLE
Inspection
INFOID:0000000009948789
COMPONENT PART
Check that the mounting conditions (looseness, backlash) of each component and component conditions
(wear, damage) are normal.
WHEEL HUB AND BEARING ASSEMBLY
Check the following items, and replace the part if necessary.
• Move wheel hub and bearing assembly in the axial direction by hand. Check there is no looseness of wheel
bearing.
• Rotate wheel hub and bearing assembly and check there is no unusual noise or other irregular conditions. If
there is any of irregular conditions, replace wheel hub and bearing assembly.
Axial end play
: Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст