Nissan March K13. Instruction — part 611
SR-22
< REMOVAL AND INSTALLATION >
SIDE CURTAIN AIR BAG MODULE
SIDE CURTAIN AIR BAG MODULE
Exploded View
INFOID:0000000006044244
Removal and Installation
INFOID:0000000006044245
WARNING:
• Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes
or more.
• Always work from the side of air bag module. Never work in front of it.
• Never use the air tools or electric tools for servicing.
REMOVAL
1.
Remove the headlining. Refer to
INT-28, "Removal and Installation"
.
2.
Disconnect the side curtain air bag module harness connector.
CAUTION:
1.
Side curtain air bag
Refer to
for symbols in the figure.
JMHIA1533GB
SIDE CURTAIN AIR BAG MODULE
SR-23
< REMOVAL AND INSTALLATION >
C
D
E
F
G
I
J
K
L
M
A
B
SR
N
O
P
• For installing/removing the side curtain air bag module
harness connector, insert thin screwdriver wrapped in
tape into notch, lift lock and remove the connector.
• Install the connector with lock raised, and push lock into
the connector.
• After installing the connector, check that the lock is
pushed securely into it.
3.
Remove the side curtain air bag module fixing bolts, and then remove the side curtain air bag module.
NOTE:
Remove bolts according to the order as shown in the figure.
CAUTION:
• Never impact the side curtain air bag module.
• Replace the side curtain air bag module if it has been dropped
or sustained an impact.
• Never insert any foreign objects (screwdriver, etc.) into the side curtain air bag module.
• Never disassemble the side curtain air bag module.
• Never expose the side curtain air bag module to temperatures exceeding 90
°
C (194
°
F).
• Never allow oil, grease, detergent, or water to come in contact with the side curtain air bag module.
INSTALLATION
Note the following item, and install in the reverse order of removal.
CAUTION:
• Never damage the harness while installing.
• If malfunction is detected by the air bag warning lamp, after repair or replacement of the malfunc-
tioning parts, reset the memory using self-diagnosis or CONSULT-III. Refer to
.
PHIA0953J
: Vehicle front
JMHIA1534ZZ
JMHIA0009ZZ
SR-24
< REMOVAL AND INSTALLATION >
SIDE CURTAIN AIR BAG MODULE
• After the work is completed, check that no system malfunction is detected by air bag warning lamp.
CRASH ZONE SENSOR
SR-25
< REMOVAL AND INSTALLATION >
C
D
E
F
G
I
J
K
L
M
A
B
SR
N
O
P
CRASH ZONE SENSOR
Exploded View
INFOID:0000000006044246
Removal and Installation
INFOID:0000000006044247
WARNING:
• Before servicing, turn ignition switch OFF, disconnect battery negative terminal and wait 3 minutes
or more.
• Never use the air tools or electric tools for servicing.
REMOVAL
1.
Remove the bumper fascia fixing clips (A).
1.
Crash zone sensor
2.
Radiator core support upper
3.
Bracket
Refer to
JMHIA1535GB
JMHIA1543ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст