Nissan March K13. Instruction — part 212
IGNITION TIMING
EC-309
< PERIODIC MAINTENANCE >
[HR12DE (TYPE 1)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
N
P
O
IGNITION TIMING
Inspection
INFOID:0000000006001762
1.
CHECK IGNITION TIMING
1.
Attach timing light (A) to loop wire (1) as shown.
2.
Check ignition timing.
>> INSPECTION END
: Vehicle front
JSBIA0378ZZ
1
: Timing indicator
MBIB1331E
EC-310
< PERIODIC MAINTENANCE >
[HR12DE (TYPE 1)]
EVAPORATIVE EMISSION SYSTEM
EVAPORATIVE EMISSION SYSTEM
Inspection
INFOID:0000000006001763
1.
Visually inspect EVAP vapor lines for improper attachment and for cracks, damage, loose connections,
chafing and deterioration.
2.
Check EVAP canister as follows:
a.
Block port (A). Orally blow air through port (B).
Check that air flows freely through port (C).
b.
Block port (B). Orally blow air through port (A).
Check that air flows freely through port (C).
3.
Inspect fuel tank filler cap vacuum relief valve for clogging, stick-
ing, etc.
a.
Wipe clean valve housing.
b.
Check valve opening pressure and vacuum.
c.
If out of specification, replace fuel filler cap as an assembly.
JSBIA0335ZZ
SEF989X
Pressure:
15.3 - 20.0 kPa (0.153 - 0.200 bar, 0.156 - 0.204 kg/
cm
2
, 2.22 - 2.90 psi)
Vacuum:
–6.0 to –3.4 kPa (–0.06 bar to –-0.034bar, –0.061 to –
0.035 kg/cm
2
, –0.87 to –0.49 psi)
SEF943S
POSITIVE CRANKCASE VENTILATION
EC-311
< PERIODIC MAINTENANCE >
[HR12DE (TYPE 1)]
C
D
E
F
G
H
I
J
K
L
M
A
EC
N
P
O
POSITIVE CRANKCASE VENTILATION
Inspection
INFOID:0000000005989425
1.
CHECK PCV VALVE
With engine running at idle, remove PCV valve from rocker cover. A
properly working valve makes a hissing noise as air passes through
it. A strong vacuum should be felt immediately when a finger is
placed over valve inlet.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Replace PCV valve.
PBIB1589E
EC-312
< REMOVAL AND INSTALLATION >
[HR12DE (TYPE 1)]
ECM
REMOVAL AND INSTALLATION
ECM
Exploded View
INFOID:0000000006001764
Removal and Installation
INFOID:0000000006001765
REMOVAL
1.
Remove battery. Refer to
.
2.
(WITH I-KEY) or
(WITHOUT I-KEY).
3.
Remove mounting nut (A) and bolts (B).
4.
Disconnect harness connectors, and then remove IPDM E/R
cover (1).
5.
Disconnect ECM harness connectors.
6.
Remove ECM mounting nuts.
7.
Remove ECM from ECM bracket.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
Must be perform additional service when replacing ECM. Refer to
.
1.
ECM bracket
2.
ECM
: Vehicle front
JSBIA0333ZZ
JSBIA0473ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст