Nissan March K13. Instruction — part 462
MIR-24
< DTC/CIRCUIT DIAGNOSIS >
DOOR MIRROR (OPEN/CLOSE MOTOR)
3.
Apply 12V to each power supply terminal of door mirror motor.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Replace door mirror. Refer to
MIR-35, "DOOR MIRROR ASSEMBLY : Removal and Installation"
.
Door mirror
Operational direction
Connector
Terminal
(+)
(–)
D23 (Driver side)
5
6
AUTO/OPEN
6
5
CLOSE
D3 (Passenger side)
5
6
AUTO/OPEN
6
5
CLOSE
ELECTRIC FOLDABLE DOOR MIRROR DOES NOT OPERATE
MIR-25
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
SYMPTOM DIAGNOSIS
ELECTRIC FOLDABLE DOOR MIRROR DOES NOT OPERATE
Diagnosis Procedure
INFOID:0000000006021974
1.
CHECK POWER SUPPLY AND GROUND CIRCUIT
Check door mirror remote control switch power supply and ground circuit.
Refer to
MIR-19, "DOOR MIRROR REMOTE CONTROL SWITCH (OPEN/CLOSE SWITCH) : Diagnosis Pro-
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning parts.
2.
CHECK DOOR MIRROR REMOTE CONTROL SWITCH (OPEN/CLOSE SWITCH)
Check door mirror remote control switch (open/close switch).
Refer to
MIR-18, "Component Inspection"
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace the malfunctioning parts.
3.
CHECK DOOR MIRROR (OPEN/CLOSE MOTOR) CIRCUIT
Check door mirror (open/close motor) circuit.
Refer to
MIR-22, "Component Function Check"
.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Repair or replace the malfunctioning parts.
4.
CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection result normal?
YES
>> Check intermittent incident. Refer to
GI-33, "Intermittent Incident"
.
NO
>> GO TO 1.
MIR-26
< SYMPTOM DIAGNOSIS >
AUTO RETRACTABLE DOOR MIRROR DOES NOT OPERATE
AUTO RETRACTABLE DOOR MIRROR DOES NOT OPERATE
Diagnosis Procedure
INFOID:0000000006021885
1.
CHECK INTELLIGENT KEY AND DOOR REQUEST SWITCH
1.
Check operation of Intelligent Key and door request switch.
Refer to
DLK-15, "DOOR LOCK FUNCTION : System Description"
.
2.
Check the operation.
Is the inspection result normal?
YES
>> Intelligent Key and door request switch are normal.
NO
>> GO TO 2.
2.
CHECK DOOR MIRROR (OPEN/CLOSE MOTOR) CIRCUIT
Check door mirror (open/close motor) circuit.
Refer to
MIR-22, "Component Function Check"
.
Is the inspection result normal?
YES
>> GO TO 3.
NO
>> Repair or replace the malfunctioning parts.
3.
CHECK AUTO RETRACTABLE DOOR MIRROR CIRCUIT
Check climate controlled seat switch.
Refer to
MIR-20, "Component Function Check"
.
Is the inspection result normal?
YES
>> GO TO 4.
NO
>> Repair or replace the malfunctioning parts.
4.
CONFIRM THE OPERATION
Confirm the operation again.
Is the inspection result normal?
YES
>> Check intermittent incident. Refer to
GI-33, "Intermittent Incident"
.
NO
>> GO TO 1.
SQUEAK AND RATTLE TROUBLE DIAGNOSES
MIR-27
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
INFOID:0000000006007919
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diag-
nostic Worksheet during the interview to document the facts and conditions when the noise occurs and any of
the customer's comments; refer to
MIR-31, "Diagnostic Worksheet"
. This information is necessary to duplicate
the conditions that exist when the noise occurs.
• The customer may not be able to provide a detailed description or the location of the noise. Attempt to obtain
all the facts and conditions that exist when the noise occurs (or does not occur).
• If there is more than one noise in the vehicle, be sure to diagnose and repair the noise that the customer is
concerned about. This can be accomplished by a test drive with the customer.
• After identifying the type of noise, isolate the noise in terms of its characteristics. The noise characteristics
are provided so the customer, service adviser and technician are all speaking the same language when
defining the noise.
• Squeak – (Like tennis shoes on a clean floor)
Squeak characteristics include the light contact/fast movement/brought on by road conditions/hard surfaces
= higher pitch noise/softer surfaces = lower pitch noises/edge to surface = chirping
• Creak – (Like walking on an old wooden floor)
Creak characteristics include firm contact/slow movement/twisting with a rotational movement/pitch depen-
dent on materials/often brought on by activity.
• Rattle – (Like shaking a baby rattle)
Rattle characteristics include the fast repeated contact/vibration or similar movement/loose parts/missing
clip or fastener/incorrect clearance.
• Knock – (Like a knock on a door)
Knock characteristics include hollow sounding/sometimes repeating/often brought on by driver action.
• Tick – (Like a clock second hand)
Tick characteristics include gentle contacting of light materials/loose components/can be caused by driver
action or road conditions.
• Thump – (Heavy, muffled knock noise)
Thump characteristics include softer knock/dead sound often brought on by activity.
• Buzz – (Like a bumble bee)
Buzz characteristics include high frequency rattle/firm contact.
• Often the degree of acceptable noise level will vary depending upon the person. A noise that a technician
may judge as acceptable may be very irritating to the customer.
• Weather conditions, especially humidity and temperature, may have a great effect on noise level.
DUPLICATE THE NOISE AND TEST DRIVE
If possible, drive the vehicle with the customer until the noise is duplicated. Note any additional information on
the Diagnostic Worksheet regarding the conditions or location of the noise. This information can be used to
duplicate the same conditions when the repair is reconfirmed.
SBT842
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст