Nissan Primera P12. Instruction — part 452
EM-154
[F9Q]
VACUUM PUMP
VACUUM PUMP
PFP:41920
Removal and Installation
EBS00SK9
REMOVAL
1.
Remove engine room cover. Refer to
.
2.
Disconnect air duct from air cleaner case. Refer to
EM-143, "AIR CLEANER AND AIR DUCT"
.
3.
Disconnect vacuum hose and connector.
4.
Remove vacuum pump.
INSTALLATION
●
Install in the reverse order of removal.
MBIB0958E
1.
Connector
2.
Vacuum hose
3.
Vacuum pump
4.
Gasket
MBIB0976E
ROCKER COVER
EM-155
[F9Q]
C
D
E
F
G
H
I
J
K
L
M
A
EM
ROCKER COVER
PFP:13264
Removal and Installation
EBS00SKA
REMOVAL
1.
Remove engine room cover. Refer to
.
2.
Disconnect PCV hose from quick connector side.
3.
Remove fuel injector harness connectors and ground cable.
4.
Disconnect camshaft position sensor harness.
5.
Remove rocker cover.
●
Loosen holding bolts in the reverse order as shown in the fig-
ure and remove.
MBIB0959E
1.
Washer
2.
Rocker cover
3.
Gasket
MBIB0975E
MBIB0960E
EM-156
[F9Q]
ROCKER COVER
INSTALLATION
1.
Tighten holding bolts in the numerical order as shown in the fig-
ure.
2.
Install in the reverse order of removal after this steps.
1st step bolt (1) : 12 N·m (1.2 kg-m, 9 ft-lb)
2nd step bolt (2) and (3) : 12 N·m (1.2 kg-m, 9 ft-lb)
3rd step bolt (1) : 12 N·m (1.2 kg-m, 9 ft-lb)
MBIB0960E
TIMING BELT
EM-157
[F9Q]
C
D
E
F
G
H
I
J
K
L
M
A
EM
TIMING BELT
PFP:13028
Removal and Installation
EBS00SKB
CAUTION:
Apply new engine oil to parts marked in illustration before installation.
REMOVAL
1.
Remove the following parts.
●
Battery ground cable
●
Undercover
●
RH front wheel
2.
Remove right side splash cover.
3.
Remove engine room cover. Refer to
.
4.
Remove front drive shaft RH side. Refer to
.
5.
Remove drive belt. Refer to
.
6.
Remove the TDC pin plug.
MBIB0963E
1.
Timing belt
2.
Timing belt tensioner
3.
Washer
4.
Front timing belt cover
5.
Crankshaft pulley
6.
Crankshaft sprocket
7.
Oil seal
8.
Front cover
9.
Gasket
MBIB0980E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст