Nissan Primera P12. Instruction — part 75
HOOD
BL-9
C
D
E
F
G
H
J
K
L
M
A
B
BL
4.
Connect cable securely to the lock.
5.
After connection, confirm proper adjustment and operation for
both hood lock and hood opener.
Hood Lock Control Inspection
EIS005GL
NOTE:
If the hood lock cable is bent or deformed, replace it.
1.
Confirm hood lock secondary latch securely engages secondary
striker by releasing it from a height of approximately 200 mm
(7.87 in).
2.
Confirm front end of the hood rises by approximately 20 mm
(0.79 in) when pulling the hood opener. Also confirm hood
opener returns to the original position.
3.
Confirm hood lock has is properly lubricated. If necessary, apply
“Grease” at the point shown in the figure.
PIIA0174E
PIIA0175E
PIIA0176E
BL-10
DOOR
DOOR
PFP:80100
Fitting Adjustment
EIS005GM
FRONT DOOR
Longitudinal Clearance and Surface Height Adjustment at Front End
1.
Remove fender protector. Refer to the section in P12 ESM (SM2E00-1P12E0E) .
2.
Working from the inside the fender, loosen hinge mount bolts on the body. Lift rear end of the front door to
adjust clearance and surface difference properly.
REAR DOOR
Longitudinal Clearance and Surface Height Adjustment at Front End
1.
Remove upper and lower garnishes on the center pillar. Refer to the section in P12 ESM (SM2E00-
1P12E0E).
2.
Loosen mounting bolts from outside of vehicle, mounting nuts from inside of vehicle. Open rear door.
Raise rear end of it to adjust.
SIIA0630E
DOOR
BL-11
C
D
E
F
G
H
J
K
L
M
A
B
BL
STRIKER ADJUSTMENT
Adjust striker until it is parallel to the lock engagement direction.
Removal and Installation
EIS005GN
NOTE:
●
During door assembly removal and installation, use a jack to support the door. Place shop cloths or some-
thing similar on the jack plate to protect the door and body from damage.
●
After door assembly removal and installation, always adjust it so will open and close smoothly.
●
Confirm the rotating part of the hinge has adequate lubrication. If necessary, apply Body Grease.
1.
Remove door finisher. Refer to EI section in P12 ESM (SM2E00-1P12E0E). .
2.
Remove sealing screen.
NOTE:
If sealing screen is reused, cut butyl tape in a way that leaves it on the sealing screen.
3.
Remove door harness.
4.
Remove check link mount bolts on the body.
5.
Remove hinge mount nuts and bolts on the door and then the
door assembly.
Install in the reverse order of removal.
PIIA0555E
SIIA0145E
SIIA0757E
BL-12
DOOR
Door Weather-strip
EIS005GO
SEDAN
WAGON
SIIA0763E
SIIA0764E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст