Nissan Versa Sedan. Instruction — part 436
EXT-30
< REMOVAL AND INSTALLATION >
TRUNK LID FINISHER
TRUNK LID FINISHER
Exploded View
INFOID:0000000009268566
Removal and Installation
INFOID:0000000009268567
REMOVAL
1. Remove trunk lid finisher inner. Refer to
INT-35, "Removal and Installation"
2. Remove trunk lid finisher nuts.
3. Disconnect the harness connectors from the license lamp.
4. Remove harness grommet.
5. Release clips and remove trunk lid finisher.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
When installing trunk lid finisher, check that clips are securely placed in body panel holes and press
them into position.
1.
Trunk lid finisher
2.
Emblem
3.
Rear view camera (if equipped)
Pawl
Clip
AWKIA2074ZZ
DOOR PARTING SEAL
EXT-31
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
DOOR PARTING SEAL
Exploded View
INFOID:0000000009268568
Removal and Installation
INFOID:0000000009268569
REMOVAL
1. Open front door and rear door.
2. Release door parting seal clips using a suitable tool (A).
: Clip
CAUTION:
Apply protective tape (B) on body to protect the painted
surface from damage.
3. Remove door parting seal.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
• Always replace double-sided tape with a new tape if door parting seal is reused.
1.
Door parting seal
2.
Double-sided tape [t: 1.6 mm (0.065 in)]
Clip
JMKIA8049ZZ
JMKIA8050ZZ
EXT-32
< REMOVAL AND INSTALLATION >
DOOR PARTING SEAL
• Do not wash the vehicle within 24 hours after installing so as to keep adhesive dry.
REAR SPOILER
EXT-33
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
REAR SPOILER
Exploded View
INFOID:0000000009268570
Removal and Installation
INFOID:0000000009268571
Removal
1. Remove trunk lid finisher (if equipped). Refer to
EXT-30, "Removal and Installation"
.
2. Disconnect high-mounted stop lamp harness connector (1).
3. Remove the rear spoiler nuts.
4. Using a suitable heating tool may also be necessary to evenly heat the rear spoiler contact surface while
releasing the tape with a suitable tool.
5. Loosen the harness grommet and gently lift the rear spoiler upward off of trunk lid.
Installation
Installation is in the reverse order of removal.
NOTE:
• Before installing rear spoiler, clean the surface where it will be mounted with isopropyl alcohol or equivalent
to degrease the surface.
1.
Rear spoiler
2.
High-mounted stop lamp harness connector
3.
Harness grommet
ALKIA2845ZZ
ALKIA2846ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст