Nissan Altima L32. Instruction — part 867
INSTRUMENT PANEL ASSEMBLY
IP-15
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
K
L
M
A
B
IP
N
O
P
18. Remove the cluster lid A (1).
19. Remove the combination meter screws (A), then remove the
combination meter (1).
• Disconnect the harness connector.
20. Remove the spiral cable. Refer to
SR-8, "Removal and Installation"
21. Remove the combination switch. Refer to
WW-121, "Removal and Installation"
22. Remove the center ventilator grilles (1).
ALJIA0026ZZ
ALJIA0027ZZ
ALJIA0029ZZ
IP-16
< ON-VEHICLE REPAIR >
INSTRUMENT PANEL ASSEMBLY
23. Remove the cluster lid C assembly upper and lower screws (A),
then remove the cluster lid C assembly (1).
• Disconnect the harness connectors.
24. Remove both tweeter speaker grilles and disconnect the harness connectors.
25. Remove the passenger air bag bolt (A).
26. Remove the remaining instrument panel screws (A).
27. Disconnect the audio harness connector located near the RH A-pillar.
28. Lift the instrument panel high enough in order to disconnect all the necessary harness connectors, then
remove the instrument panel.
INSTALLATION
Installation is in the reverse order of removal.
• If replacing the Instrument panel transfer all the necessary parts to the new instrument panel.
CENTER CONSOLE ASSEMBLY
IP-17
< DISASSEMBLY AND ASSEMBLY >
C
D
E
F
G
H
I
K
L
M
A
B
IP
N
O
P
DISASSEMBLY AND ASSEMBLY
CENTER CONSOLE ASSEMBLY
Exploded View
INFOID:0000000004205590
1.
M/T finisher
2.
CVT finisher
3.
Storage bin (if equipped)
4.
CD changer console bracket (if
equipped)
5.
CD changer bracket LH (if
equipped)
6.
CD changer bracket RH (if
equipped)
7.
CD changer finisher (if equipped)
8.
Console
9.
Console screw cover (LH)
10. Console floor bracket
11. Console rear finisher (with rear
duct)
12. Console rear finisher (without
rear duct)
13. Console lid assembly bracket
14. Console lid assembly
15. Cup holder CVT
16. Cup holder M/T
Clip
Pawl
Metal clip
ALJIA0032ZZ
IP-18
< DISASSEMBLY AND ASSEMBLY >
CENTER CONSOLE ASSEMBLY
Disassembly and Assembly
INFOID:0000000004205591
DISASSEMBLY
1. Remove the console assembly. Refer to
IP-12, "Removal and Installation"
2. Remove the cup holder screws and then remove the cup holder assembly.
3. Remove the console lid screws and remove the console lid.
4. Remove the console rear finisher.
5. Remove the console lid assembly bracket.
6. Remove the power socket from the console. Refer to
PWO-5, "Removal and Installation"
ASSEMBLY
Assembly is in the reverse order of disassembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст