Nissan Altima L32. Instruction — part 793
GW-22
< ON-VEHICLE REPAIR >
FRONT REGULATOR
• Lower the glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)] and make sure the clearance to the sash is
parallel. If the clearance between the glass and sash is not parallel, loosen the regulator mounting bolts,
guide rail mounting bolts, and glass and guide rail mounting bolts to adjust the glass position.
REAR DOOR GLASS
GW-23
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
GW
N
O
P
REAR DOOR GLASS
Exploded View
INFOID:0000000004507202
Removal and Installation
INFOID:0000000004507203
REMOVAL
1. Remove the rear door finisher. Refer to
INT-34, "Removal and Installation"
.
2. Remove the plastic vapor barrier, being careful not to tear/damage it.
3. Temporarily reconnect the power window switch to the door harness.
4. Operate the power window switch to raise/lower the door glass until the door glass bolts (A) can be seen.
5. Remove the door glass bolts (A).
1.
Rear door
2.
Door glass run
3.
Door glass
4.
Inside seal
5.
Partition sash
6.
Rear window seal
7.
Door rear, glass
8.
Regulator assembly
9.
Window motor
10. Water shield
ALKIA1456ZZ
ALKIA0117ZZ
GW-24
< ON-VEHICLE REPAIR >
REAR DOOR GLASS
6. Remove the door glass.
7. Remove the partition sash from the glass run.
• Remove the partition sash bolt (lower) (B) and screw (upper)
(A) to remove the sash.
8. Remove the partition glass from the inside of the door in the
direction as shown.
INSTALLATION
Installation is in the reverse order of removal.
• After installation inspect and adjust as necessary.
Inspection and Adjustment
INFOID:0000000004507204
FITTING INSPECTION
• Make sure the glass is securely fit into the glass run groove.
• Lower the glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)], and make sure the clearance to the sash is
parallel. If the clearance between the glass and sash is not parallel, loosen the regulator mounting bolts,
guide rail mounting bolts, and glass and carrier plate mounting bolts to correct the glass position.
ALKIA0118ZZ
ALKIA0119ZZ
REAR REGULATOR
GW-25
< ON-VEHICLE REPAIR >
C
D
E
F
G
H
I
J
L
M
A
B
GW
N
O
P
REAR REGULATOR
Exploded View
INFOID:0000000004507205
Removal and Installation
INFOID:0000000004507206
REMOVAL
1. Remove the rear door finisher. Refer to
INT-34, "Removal and Installation"
.
2. Remove the plastic vapor barrier, being careful not to tear/damage it.
3. Temporarily reconnect the power window switch to the door harness.
4. Operate the power window switch to raise/lower the door win-
dow until the glass mounting bolts (A) can be seen.
1.
Rear door
2.
Door glass run
3.
Door glass
4.
Inside seal
5.
Partition sash
6.
Rear window seal
7.
Door rear, glass
8.
Regulator assembly
9.
Window motor
10. Water shield
ALKIA0115ZZ
ALKIA0117ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст