Nissan Altima L32. Instruction — part 855
DOOR FINISHER
INT-13
< ON-VEHICLE REPAIR >
[COUPE]
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
4. Continue to move the suitable tool (A) and disengage the upper
metal clip and remove armrest finisher (1).
5. Remove the front door finisher screw beneath armrest finisher.
6. Release the clips around outer edge, then remove front door finisher.
7. Disconnect inside release handle and lock knob cables from back of front door finisher.
Installation
Installation is in the reverse order of removal.
ALJIA0241ZZ
INT-14
< ON-VEHICLE REPAIR >
[COUPE]
BODY SIDE TRIM
BODY SIDE TRIM
Exploded View
INFOID:0000000004205957
1.
Front pillar finisher
2.
Front body side welt
3.
Front kicking plate
ALJIA0220ZZ
BODY SIDE TRIM
INT-15
< ON-VEHICLE REPAIR >
[COUPE]
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
Removal and Installation
INFOID:0000000004205958
CAUTION:
• Wrap the tip of flat-bladed screwdriver with a cloth when removing metal clips from garnishes.
• When removing or installing body side welts, do not allow butyl seal to come in contact with pillar
finishers.
REMOVAL
FRONT PILLAR FINISHER
1. Remove front body side welt.
CAUTION:
Insert a suitable clip removing tool wrapped with a shop
cloth inserted into the part shown by the arrow (between
the clip and the body side panel), then release the clip.
2. Release the clips, then remove front pillar finisher.
FRONT KICKING PLATE
Release the clip and pawls, then remove front kicking plate.
FRONT BODY SIDE WELT
1. Remove front kicking plate.
2. Release welt from the body opening, then remove front body side welt.
REAR PILLAR FINISHER
1. Remove front body side welt.
2. Remove finisher tether.
3. Release the clips, then remove rear finisher.
UPPER PILLAR FINISHER
1. Remove front body side welt.
2. Remove front pillar finisher.
3. Remove seat belt anchor. Refer to
4. Release the clips, then remove upper pillar finisher.
FRONT PILLAR FINISHER
1. Remove front body side welt.
2. Remove screw.
3. Release the clips, then remove rear pillar finisher.
REAR LOWER FINISHER
1. Remove front body side welt.
2. Release the clips, then remove rear pillar finisher.
SILL PLATE COVER
Release the pawls, then remove the sill plate cover.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
4.
Front sill cover
5.
Rear lower finisher
6.
Upper pillar finisher
7.
Rear pillar finisher
Clip C101
Metal clip
PIIB2768J
INT-16
< ON-VEHICLE REPAIR >
[COUPE]
BODY SIDE TRIM
Make sure that clips are fully aligned with panel holes on body when installing, then press them in
completely.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст