Nissan Altima L32. Instruction — part 763
FRONT DRIVE SHAFT
FAX-25
< DISASSEMBLY AND ASSEMBLY >
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
6. Install boot securely into grooves (indicated by * marks) as
shown.
CAUTION:
If there is grease on boot mounting surfaces (indicated by *
marks) of shaft and housing, boot may come off. Remove
all grease from surfaces.
7. Make sure boot installation length (L) is the specified length.
Insert a flat-bladed screwdriver or similar tool into the large end
of boot. Bleed air from boot to prevent boot deformation.
CAUTION:
• Boot may break if boot installation length is less than standard value.
• Be careful that screwdriver tip does not contact inside surface of boot.
8. Install new large and small boot bands securely using Tool.
NOTE:
Do not reuse boot bands.
CAUTION:
• Secure boot band so that dimension (M) meets specifica-
tion as shown.
9. After installing housing and shaft, rotate boot to check whether or not the actual position is correct. If boot
position is not correct, remove old boot bands then reposition the boot and secure with new boot bands.
Support Bearing
1. With QR25DE engine, press support bearing into retaining bracket using a suitable tool.
2. Install support bearing onto slide joint assembly.
3. Install snap ring.
4. Install dust shield.
Damper
Boot installation length (L)
: 163 mm (6.42 in)
Tool number
: KV40107300 (
—
)
SDIA1505E
RAC1133D
Dimension (M)
: 1.0 – 4.0 mm (0.039 – 0.157 in)
DSF0047D
FAX-26
< DISASSEMBLY AND ASSEMBLY >
FRONT DRIVE SHAFT
1. Use new damper bands for installation.
2. Install damper from stationary-joint side while holding it securely.
(A)
: 205 – 215 mm (8.07 – 8.46 in)
(B)
: 70 mm (2.76 in)
SFA313B
SERVICE DATA AND SPECIFICATIONS (SDS)
FAX-27
< SERVICE DATA AND SPECIFICATIONS (SDS)
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Wheel Bearing
INFOID:0000000004205635
Drive Shaft
INFOID:0000000004205636
Dynamic Damper
INFOID:0000000004205637
Axial end play limit
0.05 mm (0.002 in) or less
Joint type
Wheel side
Transaxle side
LH
RH
LH
RH
Grease quantity
170 - 190 g (6.00 - 6.70 oz)
134 - 144 g (4.73 - 5.08 oz)
Boots installed length
163 mm (6.42 in)
167.9 mm (6.61 in)
189.30 (7.45 in)
SDIA1505E
"A"
205 - 215 mm (8.07 -8.46 in)
"B"
70 mm (2.76 in)
SFA313B
FAX-28
< SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Boot Bands
INFOID:0000000004497112
Unit: mm (in)
Dimension (M)
1.0 - 4.0 (0.039 - 0.157)
DSF0047D
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст