Nissan Altima L32. Instruction — part 1393
HYDRAULIC LINE
ST-25
< ON-VEHICLE REPAIR >
C
D
E
F
H
I
J
K
L
M
A
B
ST
N
O
P
REMOVAL AND INSTALLATION
Removal
ST-24, "VQ35DE : With 18 Inch Tire"
for removal procedure.
1.
High pressure hose
2.
Suction hose
3.
Reservoir tank bracket
4.
Reservoir tank
5.
Oil pump assembly
6.
Power steering fluid cooler
7.
Power steering fluid cooler brackets 8.
Steering gear assembly
9.
Low pressure piping
10. Eye-bolt
11. High pressure piping
12.
Copper washer
13. eye bolt
14. Copper washer
15.
Pressure sensor
16. Eye-joint (assembled to high-pres-
sure side hose)
ALGIA0046GB
ST-26
< ON-VEHICLE REPAIR >
HYDRAULIC LINE
Installation
CAUTION:
Do not apply fluid.
• Install eye-bolt with eye-joint (assembled to high-pressure hose)
protrusion facing with pump side cutout, and then tighten it to the
specified torque after tightening by hand.
• Install check valve with eye-joint (assembled to high pressure
tube) protrusion facing gear side and tighten it to the specified
torque after tightening by hand.
CAUTION:
Do not reuse copper washers.
SGIA0515E
ALGIA0049GB
STEERING COLUMN
ST-27
< DISASSEMBLY AND ASSEMBLY >
C
D
E
F
H
I
J
K
L
M
A
B
ST
N
O
P
DISASSEMBLY AND ASSEMBLY
STEERING COLUMN
Disassembly and Assembly
INFOID:0000000004204031
CAUTION:
• Any time the ignition switch has been disconnected, removed or installed, the keys must be re-regis-
tered in the BCM. Refer to Consult-III operations IVIS/NVIS.
The steering column assembly is not serviceable and must be replaced as an assembly.
ST-28
< DISASSEMBLY AND ASSEMBLY >
STEERING GEAR AND LINKAGE
STEERING GEAR AND LINKAGE
Exploded View
INFOID:0000000004204032
Disassembly
INFOID:0000000004204033
1. Remove outer socket locknut and outer socket
2. Remove boot clamps and boot.
3. Remove inner socket.
Inspection
INFOID:0000000004204034
INSPECTION AFTER DISASSEMBLY
Boot
Check boot for cracks. Replace if there are.
Outer Socket and Inner Socket
1. Ball joint swinging torque
1.
Outer socket
2.
Boot clamp
3.
Boot
4.
Inner socket
5.
Boot clamp
6.
SSPS valve (part of gear assembly)
7.
Gear assembly
⇐
Front
Three Bound TB1111 or equivalent
AWGIA0010GB
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст