Nissan Altima L32. Instruction — part 861
BODY SIDE TRIM
INT-37
< ON-VEHICLE REPAIR >
[SEDAN]
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
3. Release the clips, then remove rear pillar finisher.
SILL PLATE COVER (FRONT/REAR)
Release the pawls, then remove the sill plate cover.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Make sure that clips are fully aligned with panel holes on body when installing, then press them in
completely.
INT-38
< ON-VEHICLE REPAIR >
[SEDAN]
REAR PARCEL SHELF FINISHER
REAR PARCEL SHELF FINISHER
Exploded View
INFOID:0000000004205978
Removal and Installation
INFOID:0000000004205979
REMOVAL
1. Release seatback latch RH/LH, then fold both rear seatbacks to forward most position.
2. Remove the clips, then remove rear seatback latch cover.
3. Lift seatback release cover, release the tabs and remove seatback release escutcheon from rear parcel
shelf finisher.
4. Remove high mounted stop lamp (if equipped). Refer to
INT-36, "Removal and Installation"
5. Remove rear pillar finisher RH/LH. Refer to
INT-36, "Removal and Installation"
.
6. Thread the rear seat belt RH/LH/Center through vertical opening and release from rear parcel shelf fin-
isher.
7. Remove the clips, then remove rear parcel shelf finisher.
1.
Seatback release escutcheon
2.
Seatback release cover
3.
Child anchor cover
4.
Seatback latch cover
5.
Rear parcel shelf finisher
6.
High mounted stop lamp (if equipped)
A.
Clip C205
Clip C101
Vehicle front
ALJIA0003ZZ
REAR PARCEL SHELF FINISHER
INT-39
< ON-VEHICLE REPAIR >
[SEDAN]
C
D
E
F
G
H
I
K
L
M
A
B
INT
N
O
P
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Make sure that clips are fully aligned with panel holes on body when installing, then press them in
completely.
INT-40
< ON-VEHICLE REPAIR >
[SEDAN]
FLOOR TRIM
FLOOR TRIM
Exploded View
INFOID:0000000004205980
Removal and Installation
INFOID:0000000004205981
REMOVAL
1. Remove front seat (RH/LH) and rear seat cushion. Refer to
SE-51, "Removal and Installation"
and
2. Remove lower body side trim. Refer to
INT-36, "Removal and Installation"
.
3. Remove center console. Refer to
IP-12, "Removal and Installation"
1.
Spacer (RH)
2.
Spacer (LH)
3.
Floor mat hook
4.
Floor carpet
5.
Harness clamp
Vehicle front
ALJIA0004ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст