Nissan Altima L32. Instruction — part 758
PREPARATION
FAX-5
< PREPARATION >
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
PREPARATION
PREPARATION
Special Service Tool
INFOID:0000000004205626
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tool
INFOID:0000000004205627
Tool number
(Kent-Moore No.)
Tool name
Description
HT72520000
(J-25730-A)
Ball joint remover
Removing outer tie-rod
KV38106700
(J-34296)
KV38106800
(J-34297)
Differential side oil seal protector
Installing drive shaft
LH: KV38106700 (J-34296)
RH: KV38106800 (J-34297)
KV40107300
(
—
)
Boot Band crimping tool
Installing boot bands
KV40107500
(
—
)
Drive shaft attachment
Removing drive shaft
NT146
NT147
ZZA1229D
ZZA1230D
Tool name
Description
Power tool
Removing nuts and bolts
PBIC0190E
FAX-6
< ON-VEHICLE MAINTENANCE >
FRONT WHEEL HUB
ON-VEHICLE MAINTENANCE
FRONT WHEEL HUB
Inspection
INFOID:0000000004205628
• Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of
wheel bearing.
• Rotate wheel hub and make sure that is no unusual noise or other irregular conditions. If there is any of
irregular conditions, replace wheel hub and bearing assembly
Axial end play
: 0.05 mm (0.002 in) or less
FRONT DRIVE SHAFT
FAX-7
< ON-VEHICLE MAINTENANCE >
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
FRONT DRIVE SHAFT
Inspection
INFOID:0000000004205629
• Check drive shaft mounting point and joint for looseness and other damage.
• Check boot for cracks and other damage.
CAUTION:
Replace entire drive shaft assembly when noise or vibration occur from drive shaft.
FAX-8
< ON-VEHICLE REPAIR >
FRONT WHEEL HUB AND KNUCKLE
ON-VEHICLE REPAIR
FRONT WHEEL HUB AND KNUCKLE
Removal and Installation
INFOID:0000000004205630
REMOVAL
1. Remove wheel and tire from vehicle. Refer to
.
2. Remove brake caliper using power tool, leaving brake caliper hydraulic lines connected. Reposition brake
caliper aside with wire. Refer to
BR-30, "BRAKE CALIPER ASSEMBLY : Exploded View"
.
NOTE:
Avoid depressing brake pedal while brake caliper is removed.
3. Put alignment marks on disc rotor and wheel hub and bearing
assembly, then remove disc rotor.
4. Remove wheel sensor from steering knuckle. Refer to
(TCS/ABS),
BRC-236, "Removal and Installation"
(VDC/TCS/ABS).
CAUTION:
Do not pull on wheel sensor harness.
5. Remove cotter pin, then remove lock nut from drive shaft using
power tool.
6. Remove steering outer tie-rod cotter pin at steering knuckle,
then loosen nut using power tool. Refer to
.
1.
Cotter pin
2.
Disc rotor
3.
Wheel hub and bearing assembly
4.
Splash guard
5.
Steering knuckle
Front
AWDIA0634GB
SDIA1480E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст