Nissan Terrano model r20 series 2004. Instruction — part 336
Symbol No.
Shapes
Removal & Installation
CG101
SBF145B
SBF085B
CE117
SBF174D
SBF175DA
CE801
YBT091
YBT092
CR103
SBF768B
SBF770B
CS103
YBT094
SBF992G
CLIP AND FASTENER
Description (Cont’d)
BT-4
Checking Body Corrosion
Visually check the body sheet metal panel for corrosion, paint damage (scratches, chipping, rubbing, etc.) or
damage to the anti-corrosion materials. In particular, check the following locations.
Hemmed portion
Hood front end, door lower end, back door rear end, etc.
Panel joint
Side sill of rear fender and center pillar, rear wheel housing of rear fender, around strut tower in engine
compartment, etc.
Panel edge
Back door opening, sunroof opening, fender wheelarch flange, fuel filler lid flange, around holes in panel, etc.
Parts contact
Waist molding, windshield molding, bumper, etc.
Protectors
Damage or condition of mudguard, fender protector, chipping protector, etc.
Anti-corrosion materials
Damage or separation of anti-corrosion materials under the body.
Drain holes
Condition of drain holes at door and side sill.
When repairing corroded areas, refer to the Corrosion Repair Instruction.
CHASSIS AND BODY MAINTENANCE
BT-5
Removal and Installation
I
When removing or installing hood, place a cloth or other padding on hood. This prevents vehicle body from
being scratched.
I
Bumper fascia is made of plastic. Do not use excessive force and be sure to keep oil away from it.
I
Hood adjustment: Adjust at hinge portion.
I
Hood lock adjustment: After adjusting, check hood lock control operation. Apply a coat of grease to hood
locks engaging mechanism.
I
Hood opener: Do not attempt to bend cable forcibly. Doing so increases effort required to unlock hood.
BODY FRONT END
BT-6
FRONT BUMPER ASSEMBLY
YBT116
BODY FRONT END
Removal and Installation (Cont’d)
BT-7
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст