Nissan Terrano model r20 series 2004. Instruction — part 246
Low one-way clutch inner race
I
Check frictional surface of inner race for wear or damage.
I
Install a new seal rings onto low one-way clutch inner race.
I
Be careful not to expand seal ring gap excessively.
I
Measure seal ring-to-groove clearance.
Inspection standard:
Standard value: 0.10 - 0.25 mm (0.0039 - 0.0098 in)
Allowable limit: 0.25 mm (0.0098 in)
I
If not within allowable limit, replace low one-way clutch inner
race.
ASSEMBLY
1. Install needle bearing onto one-way clutch inner race.
I
Pay attention to its direction — Black surface goes to rear
side.
I
Apply petroleum jelly to needle bearing.
2. Install oil seal and D-ring onto piston.
I
Apply ATF to oil seal and D-ring.
3. Install piston by rotating it slowly and evenly.
I
Apply ATF to inner surface of transmission case.
SAT877A
SAT878A
SAT112B
SAT879A
SAT880A
REPAIR FOR COMPONENT PARTS
Low & Reverse Brake (Cont’d)
AT-168
4. Install return springs, spring retainer and low one-way clutch
inner race onto transmission case.
5. Install dish plate, low and reverse brake drive plates, driven
plates and retaining plate.
6. Install snap ring on transmission case.
7. Check operation of low and reverse brake clutch piston. Refer
to “DISASSEMBLY”, AT-166.
8. Measure clearance between retaining plate and snap ring.
If not within allowable limit, select proper retaining plate.
Specified clearance:
Standard
0.8 - 1.1 mm (0.031 - 0.043 in)
Allowable limit
2.5 mm (0.098 in)
Retaining plate:
Refer to SDS, AT-203.
9. Install low one-way clutch inner race seal ring.
I
Apply petroleum jelly to seal ring.
I
Make sure seal rings are pressed firmly into place and held
by petroleum jelly.
SAT881A
SAT872A
SAT885A
SAT884A
REPAIR FOR COMPONENT PARTS
Low & Reverse Brake (Cont’d)
AT-169
Forward Clutch Drum Assembly
DISASSEMBLY
1. Remove snap ring from forward clutch drum.
2. Remove side plate from forward clutch drum.
3. Remove low one-way clutch from forward clutch drum.
4. Remove snap ring from forward clutch drum.
5. Remove needle bearing from forward clutch drum.
SAT211GA
SAT212G
SAT213G
SAT891A
REPAIR FOR COMPONENT PARTS
AT-170
INSPECTION
Forward clutch drum
I
Check spline portion for wear or damage.
I
Check frictional surfaces of low one-way clutch and needle
bearing for wear or damage.
Needle bearing and low one-way clutch
I
Check frictional surface for wear or damage.
ASSEMBLY
1. Install needle bearing in forward clutch drum.
2. Install snap ring onto forward clutch drum.
3. Install low one-way clutch onto forward clutch drum by pushing
the roller in evenly.
I
Install low one-way clutch with flange facing rearward.
SAT892A
SAT893A
SAT214G
SAT894A
SAT895A
REPAIR FOR COMPONENT PARTS
Forward Clutch Drum Assembly (Cont’d)
AT-171
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст