Nissan Terrano model r20 series 2004. Instruction — part 289
Precautions
I
When installing each rubber part, final tightening must be car-
ried out under unladen condition* with tires on ground.
*
Fuel, radiator coolant and engine oil full. Spare tire, jack,
hand tools and mats in designated positions.
I
Use Tool when removing or installing brake tubes.
I
If suspension or suspension parts are dismounted, check wheel
alignment and adjust if necessary.
I
Do not jack up vehicle at lower link.
Preparation
SPECIAL SERVICE TOOLS
*: Special tool or commercial equivalent
Tool number
Tool name
Description
GG94310000*
Flare nut torque wrench
Removing or installing brake piping
KV40101000*
Axle stand
Removing rear axle shaft
ST36230000*
Sliding hammer
Removing rear axle shaft
ST38020000
Bearing lock nut wrench
Removing wheel bearing lock nut
KV401-06700-B
Rear axle shaft bearing
puller
Remove wheel bearing and ABS rotor
NI-110
Rear axle shaft guide
Installing rear axle shaft
SBR820B
PRECAUTIONS AND PREPARATION
RA-2
Tool number
Tool name
Description
NI-104
Rear axle bearing
removal installation kit
Install and remove rear wheel bearing and
shaft
PRECAUTIONS AND PREPARATION
Preparation (Cont’d)
RA-3
YRA008
REAR AXLE AND REAR SUSPENSION
RA-4
Rear Axle and Rear Suspension Parts
Check rear axle and rear suspension parts for looseness, wear or
damage.
I
Shake each rear wheel to check for excessive play.
I
Retighten all nuts and bolts to the specified torque.
Tightening torque: refer to REAR AXLE AND REAR
SUSPENSION, RA-4.
I
Check shock absorber for oil leakage or other damage.
Rear Wheel Bearing
I
Check that wheel bearings operate smoothly.
I
Check axial end play.
Axial end play:
Refer to SDS, RA-16.
SMA525A
SRA734
YRA003
CHECK AND ADJUSTMENT
RA-5
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст