Nissan Silvia. Instruction — part 67
SAT912A
5.
Install servo piston spring retainer, return spring C and piston
stem onto band servo piston.
SAT921A
6.
Place piston stem end on a wooden block. While pushing
servo piston spring retainer down, install E-ring.
SAT922A
7.
Install band servo piston assembly onto servo piston retainer
by pushing it inward.
SAT923A
8.
Install D-ring on OD band servo piston.
I
Apply ATF to D-ring.
SAT924A
9.
Install OD band servo piston onto servo piston retainer by
pushing it inward.
GI
MA
EM
LC
EC
FE
CL
MT
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
REPAIR FOR COMPONENT PARTS
Band Servo Piston Assembly (Cont’d)
AT-265
Parking Pawl Components
COMPONENTS
NMAT0152
SAT836J
SAT226H
DISASSEMBLY
NMAT0153
1.
Slide return spring to the front of adapter case flange.
2.
Remove return spring, parking pawl spacer and parking pawl
from adapter case.
3.
Remove parking pawl shaft from adapter case.
SAT228H
4.
Remove parking actuator support from adapter case.
SAT998G
INSPECTION
NMAT0209
Parking Pawl and Parking Actuator Support
NMAT0209S01
I
Check contact surface of parking rod for wear.
REPAIR FOR COMPONENT PARTS
Parking Pawl Components
AT-266
SAT229H
ASSEMBLY
NMAT0154
1.
Install parking actuator support onto adapter case.
2.
Insert parking pawl shaft into adapter case.
3.
Install return spring, pawl spacer and parking pawl onto park-
ing pawl shaft.
SAT226H
4.
Bend return spring upward and install it onto adapter case.
GI
MA
EM
LC
EC
FE
CL
MT
PD
AX
SU
BR
ST
RS
BT
HA
SC
EL
IDX
REPAIR FOR COMPONENT PARTS
Parking Pawl Components (Cont’d)
AT-267
SAT931A
Assembly (1)
NMAT0155
1.
Install instruction shaft components.
a.
Install oil seal onto instruction shaft.
I
Apply ATF to oil seal.
I
Wrap threads of instruction shaft with masking tape.
b.
Insert instruction shaft and oil seal as a unit into transmission
case.
c.
Remove masking tape.
SAT932A
d.
Push oil seal evenly and install it onto transmission case.
SAT933A
e.
Align groove in shaft with retaining pin hole, then retaining pin
into position as shown in figure at left.
SAT901E
f.
Install detent spring and spacer.
g.
While pushing detent spring down, install instruction plate onto
instruction shaft.
SAT936A
h.
Install lock nuts onto instruction shaft.
ASSEMBLY
Assembly (1)
AT-268
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст