Nissan Silvia. Instruction — part 120

Components

NMCL0013

SCL883

CL145

Removal and Installation

NMCL0014

I

Remove release bearing.

SCL705

I

Install release bearing with suitable drift.

SCL217

I

Install retainer spring and holder spring.

GI

MA

EM

LC

EC

FE

MT

AT

PD

AX

SU

BR

ST

RS

BT

HA

SC

EL

IDX

CLUTCH RELEASE MECHANISM

Components

CL-13

Inspection

NMCL0015

Check the following items, and replace if necessary.

I

Release bearing, to see that it rolls freely and is free from
noise, cracks, pitting or wear

I

Release sleeve and withdrawal lever rubbing surface, for wear,
rust or damage

SCL827

Lubrication

NMCL0016

I

Apply recommended grease to contact surface and rubbing
surface.

I

Too much lubricant might damage clutch disc facing.

CLUTCH RELEASE MECHANISM

Inspection

CL-14

Components

NMCL0018

SCL675-D

SCL229

Inspection and Adjustment

NMCL0019

CLUTCH DISC

NMCL0019S01

Check the following items, and replace if necessary.

I

Clutch disc, for burns, discoloration, oil or grease leakage

I

Clutch disc, for wear of facing

Wear limit of facing surface to rivet head:

0.3 mm (0.012 in)

SCL221

I

Clutch disc, for backlash of spline and runout of facing

Maximum backlash of spline (at outer edge of disc):

1.0 mm (0.039 in)

Runout limit:

1.0 mm (0.039 in)

Distance of runout check point (from hub center):

115 mm (4.53 in)

SCL466-A

CLUTCH COVER AND FLYWHEEL

NMCL0019S02

I

Check clutch cover, installed on vehicle, for uneven diaphragm
spring toe height.

Uneven limit:

0.7 mm (0.028 in)

I

If out of limit, adjust the height with Tool.

GI

MA

EM

LC

EC

FE

MT

AT

PD

AX

SU

BR

ST

RS

BT

HA

SC

EL

IDX

CLUTCH DISC, CLUTCH COVER AND FLYWHEEL

Components

CL-15

AEM100

FLYWHEEL INSPECTION

NMCL0019S03

CAUTION:

Do not allow any magnetic materials to contact the ring gear
teeth.

I

Inspect contact surface of flywheel for slight burns or discol-
oration. Clean flywheel with emery paper.

I

Check flywheel runout.

Maximum allowable runout:

Refer to EM-77, “Flywheel/Drive plate Runout”.

SCL884

Installation

NMCL0020

I

Insert Tool into clutch disc hub when installing clutch cover and
disc.

I

Be careful not to allow grease to contaminate clutch facing.

I

Tighten bolts in numerical order, in two steps.

First step:

: 10 - 20 N·m (1.0 - 2.0 kg-m, 7 - 14 ft-lb)

Final step:

: 35 - 44 N·m (3.5 - 4.5 kg-m, 26 - 32 ft-lb)

CLUTCH DISC, CLUTCH COVER AND FLYWHEEL

Inspection and Adjustment (Cont’d)

CL-16