Nissan Terrano r20e. Instruction — part 30
10. Remove starter motor.
11. Remove gusset and rear plate cover securing engine to A/T
assembly.
12. Remove bolts securing torque converter to drive plate.
I
Remove the bolts by turning crankshaft.
13. Support A/T and transfer assembly with a jack.
14. Remove rear engine mounting member from body and A/T
assembly. Tighten rear engine mounting member to the speci-
fied torque. Refer to EM section (“ENGINE REMOVAL”).
15. Remove bolts securing A/T assembly to engine.
I
Secure torque converter to prevent it from dropping.
I
Secure A/T assembly with transfer to a jack.
16. Lower A/T assembly with transfer.
Installation
I
Drive plate runout
Do not allow any magnetic materials to contact the ring gear
teeth.
Maximum allowable runout:
Refer to EM section (“Inspection”, CYLINDER
BLOCK).
If this runout is out of specification, replace drive plate with ring
gear.
I
When connecting torque converter to transmission, measure
distance “A” to be certain that they are correctly assembled.
Distance “A”:
26.0 mm (1.024 in) or more
I
Install converter to drive plate.
I
After converter is installed to drive plate, rotate crankshaft
several turns and check to be sure that transmission
rotates freely without binding.
SAT801C
SAT977H
SAT017B
NAT286
REMOVAL AND INSTALLATION
Removal (Cont’d)
AT-117
I
Tighten bolts securing transmission.
Bolt No.
Tightening torque
N
⋅
m (kg-m, ft-lb)
Bolt length “
”
mm (in)
q
1
39 - 49 (4.0 - 5.0, 29 - 36)
58.0 (2.28)
q
2
29 - 39 (3.0 - 4.0, 22 - 29)
90.0 (3.54)
q
3
18 - 22 (1.8 - 2.2, 13 - 16)
16.0 (0.63)
q
4
3 - 4 (0.3 - 0.4, 2.2 - 2.9)
12.0 (0.47)
q
5
29 - 39 (3.0 - 4.0, 22 - 29)
35.0 (1.38)
I
Reinstall any part removed.
I
Check fluid level in transmission.
I
Move selector lever through all positions to be sure that trans-
mission operates correctly.
With parking brake applied, rotate engine at idling. Move selec-
tor lever through “N” to “D”, to “2”, to “1” and to “R” positions.
A slight shock should be felt by hand gripping selector each
time transmission is shifted.
I
Perform road test. Refer to “ROAD TEST”, AT-32.
NAT287
SAT638A
REMOVAL AND INSTALLATION
Installation (Cont’d)
AT-118
NAT223
MAJOR OVERHAUL
AT-119
YAT342
MAJOR OVERHAUL
AT-120
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст