Nissan Primera P11. Instruction — part 515
Shift Control Components
INSPECTION
I
Check contact surface and sliding surface for wear, scratches,
projections or other damage.
SMT703B
Striking rod
Control bracket
Shift fork and
shifter cap
SMT727B
REPAIR FOR COMPONENT PARTS
RS5F32A
Shift Control Components
MT-35
ADJUSTMENT OF INPUT SHAFT BRAKING
MECHANISM
1.
Install striking lever & rod, striking interlock assembly and con-
trol bracket on clutch housing exactly.
I
When installing control bracket on clutch housing, assure
protrusion beneath bracket is correctly seated.
2.
Measure maximum height “H” while shifting from neutral to
reverse position.
Maximum height “H”:
67.16 - 67.64 mm (2.6441 - 2.6630 in)
3.
Remove control bracket from clutch housing.
4.
Measure clearance “C” between reverse brake cam and strik-
ing lever at reverse position.
Clearance “C”:
0.05 - 0.125 mm (0.0020 - 0.0044 in)
5.
If height “H” and clearance “C” are not within specifications,
replace control bracket, striking lever and striking interlock
assembly as a set.
SMT774B
Control bracket
Clutch housing
SMT728B
1st & 2nd shifter
Height
gauge
1st & 2nd shifter
Striking lever
Control bracket
fitting surface
.
Reverse brake cam
SMT729B
Reverse brake cam
Striking lever
REPAIR FOR COMPONENT PARTS
RS5F32A
Shift Control Components (Cont’d)
MT-36
Case Components
REMOVAL AND INSTALLATION
Input shaft oil seal
I
Apply multi-purpose grease to seal lip of oil seal before
installing.
Input shaft rear bearing
1.
Remove welch plug from transmission case.
2.
Remove input shaft rear bearing by tapping it from welch plug
hole.
3.
Install welch plug.
I
Apply recommended sealant to mating surface of trans-
mission case.
SMT660A
Drift
SMT751BA
KV38102100
SMT705B
SMT704B
SMT705B
REPAIR FOR COMPONENT PARTS
RS5F32A
Case Components
MT-37
4.
Install input shaft rear bearing.
Mainshaft front bearing and oil channel
1.
Remove mainshaft front bearing retainer.
2.
Remove mainshaft front bearing.
3.
Remove oil channel.
4.
Install oil channel.
I
Ensure that oil groove in oil channel always faces toward
oil pocket when installing it on clutch housing.
5.
Install mainshaft front bearing.
6.
Install mainshaft front bearing retainer.
I
Apply locking sealant to thread of screw before installa-
tion.
SMT706B
SMT707B
Bearing
retainer
SMT714B
Mainshaft
front bearing
SMT595
Oil groove
Toward
oil pocket
SMT752BA
Drift
REPAIR FOR COMPONENT PARTS
RS5F32A
Case Components (Cont’d)
MT-38
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст