Nissan Primera P11. Instruction — part 28
6
CHECK THROTTLE POSITION SWITCH CIRCUIT (Without CONSULT-II)
Without CONSULT-II
1. Turn ignition switch to “ON” position.
(Do not start engine.)
2. Check voltage between TCM terminals 16, 17 and ground while depressing, and releasing accelerator pedal slowly. (After warming up
engine)
SAT454J
OK or NG
OK
©
GO TO 7.
NG
©
Check the following items:
I
Throttle position switch — Refer to “Components Inspection”, AT-85.
I
Harness for short or open between ignition switch and throttle position switch (Main
harness)
I
Harness for short or open between throttle position switch and TCM (Main harness)
Accelerator pedal
condition
Voltage
Terminal No. 16
Terminal No. 17
Released
Battery voltage
1V or less
Fully depressed
1V or less
Battery voltage
MTBL0137
7
CHECK DTC
Perform Diagnostic Trouble Code (DTC) confirmation procedure, AT-103.
OK or NG
OK
©
INSPECTION END
NG
©
1. Perform TCM input/output signal inspection.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness con-
nector.
TROUBLE DIAGNOSES FOR NON-DETECTABLE ITEMS
PNP Switch, Stop Lamp Switch and Throttle Position Switch (Cont’d)
AT-109
Wiring Diagram — AT — NONDTC
MODELS BEFORE VIN - P11U0548750
NCAT0237
YAT155
BATTERY
IGNITION SWITCH
ON or START
FUSE
BLOCK
(J/B)
Refer to
EL-POWER.
TCM
(TRANSMISSION
CONTROL MODULE)
Detectable line for DTC
Non-detectable line for DTC
Hyper CVT models
Hyper CVT M6 models
SPORT indicator lamp
CVT warning lamp
UNIFIED METER CONTROL UNIT
COMBINATION
METER
INDICATOR
CONTROL
UNIT
REFER TO THE FOLLOWING
FUSE BLOCK - Junction Box (J/B)
TROUBLE DIAGNOSES FOR NON-DETECTABLE ITEMS
Wiring Diagram — AT — NONDTC
AT-110
MODELS AFTER VIN - P11U0548750
YAT253
TROUBLE DIAGNOSES FOR NON-DETECTABLE ITEMS
Wiring Diagram — AT — NONDTC (Cont’d)
AT-111
YAT254
TROUBLE DIAGNOSES FOR NON-DETECTABLE ITEMS
Wiring Diagram — AT — NONDTC (Cont’d)
AT-112
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст