Nissan Primera P11. Instruction — part 330
WIPER OPERATION
Without variable intermittent
The wiper motor operates the wiper arms at an interval of approximately 7 seconds. This feature is controlled
by the combination switch wiper amplifier.
When the wiper switch is placed in the INT position, ground is supplied
●
to front wiper relay terminal
쑗
5
●
from wiper switch terminal
쑗
13
●
to wiper motor terminal
쑗
2
●
through the wiper switch terminal
쑗
14
●
to wiper switch terminal
쑗
13
●
through front wiper relay terminal
쑗
3
WASHER OPERATION
With the ignition switch in the ON or START position, power is supplied
●
through 10A fuse (No.
21
, located in the fuse block)
●
to washer switch terminal
쑗
5
.
When the lever is pulled to the WASH/F position, ground is supplied
●
to washer motor terminal
쑗
2
●
from terminal
쑗
18
of the wiper switch
●
through terminal
쑗
4
of the wiper switch, and
●
through body grounds
E37
and
E11
.
Power is supplied
●
from terminal
쑗
3
of the washer switch
●
to washer motor terminal
쑗
1
.
With power and ground supplied, the washer motor operates.
When the lever is pulled to the WASH position for one second or more, the wiper motor operates at low speed
for approximately 3 seconds to clean windshield. This feature is controlled by the combination switch (wiper
amplifier) in the same manner as the intermittent operation.
FRONT WIPER AND WASHER
System Description (Cont’d)
EL-187
Wiring Diagram — WIPER —
YEL175C
IGNITION SWITCH
ON or START
FUSE BLOCK
(J/B)
Refer to EL-POWER.
Next page
Next page
Next
page
COMBINATION
SWITCH
(FRONT WIPER
SWITCH)
LOW
HIGH
FRONT WIPER
MOTOR
Next page
Next page
: LHD models
: RHD models
REFER TO THE FOLLOWING
FUSE BLOCK - Junction Box (J/B)
OFF
MIST
OFF
INT
LO
HI
OFF
INT
LO
HI
FRONT WIPER AND WASHER
EL-188
YEL882C
FRONT WIPER AND WASHER
Wiring Diagram — WIPER — (Cont’d)
EL-189
Removal and Installation
WIPER ARMS
1. Prior to wiper arm installation, turn on wiper switch to oper-
ate wiper motor and then turn it “OFF” (Auto Stop).
2. Lift the blade up and then set it down onto glass surface. Set
the blade center to clearance “C” immediately before tight-
ening nut.
3. Eject washer fluid. Turn on wiper switch to operate wiper
motor and then turn it “OFF”.
4. Ensure that wiper blades stop within clearance “C”.
Clearance “C”: 19 - 33 mm (0.75 - 1.30 in)
●
Tighten windshield wiper arm nuts to specified torque.
: 21 - 26 N·m (2.1 - 2.7 kg-m, 15 - 20 ft-lb)
●
Before reinstalling wiper arm, clean up the pivot area as
illustrated. This will reduce possibility of wiper arm
looseness.
NEL310
Clearance “C”
(Passenger side)
Clearance “C”
(Driver side)
Cowl top seal
SEL024J
FRONT WIPER AND WASHER
EL-190
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст