Nissan Frontier D22. Instruction — part 893
RSU-6
REAR SUSPENSION ASSEMBLY
2WD VG33E AND VG33ER MODEL
4WD MODEL
LEIA0021E
LEIA0022E
ON-VEHICLE SERVICE
RSU-7
C
D
F
G
H
I
J
K
L
M
A
B
RSU
ON-VEHICLE SERVICE
PFP:00000
Component
EES000XF
Rear Suspension
CAUTION:
When installing the rubber components, the final tightening of the nuts and bolts must be done with
the vehicle in an unladen condition (the fuel, engine coolant, and engine oil at full; the spare tire, jack,
hand tools and mats in their designated positions) with the tires on the ground.
NOTE:
The early production rear spring clip U-bolt is a fine thread with a washer and nut. The late production rear
spring clip U-bolt is a coarse thread with a self-locking flange nut, a new flange nut must be used for installa-
tion.
Rear Suspension Parts
EES000XG
●
Check the rear suspension parts for any excessive play, cracks, wear, and other damage.
WEIA0024E
1.
Bumper
2.
Rear spring shackle
3.
Rear spring plate
4.
Rear spring bushing
5.
Rear leaf spring
6.
Shock absorber
7.
Rear spring pad
8.
Rear spring front bolt
9.
Rear spring bushing
10. Rear spring clip U-bolt
11.
Shock absorber (right side)
12. Shock absorber (left side)
13. Nut (and washer if equipped)
RSU-8
ON-VEHICLE SERVICE
●
Shake each rear wheel to check for any excessive play as
shown.
●
Tighten all of the nuts and bolts to the specified torque.
Refer to
CAUTION:
When installing the rubber components, the final tightening
of the nuts and bolts must be done with the vehicle in an
unladen condition (the fuel, engine coolant, and engine oil
at full; the spare tire, jack, hand tools and mats in their des-
ignated positions) with the tires on the ground.
●
Check the shock absorber for oil leakage and other damage as
shown.
●
Check the shock absorber bushings for excessive wear and other damage.
SMA525A
ASU031
SRA734
SHOCK ABSORBER
RSU-9
C
D
F
G
H
I
J
K
L
M
A
B
RSU
SHOCK ABSORBER
PFP:56210
Removal and Installation
EES000XH
1.
Remove shock absorber by disconnecting upper and lower end.
2.
Install in the reverse order of removal.
Inspection
EES000XI
●
If oil leakage, cracks and deformation occurs, replace shock absorber assembly.
●
If rubber bushings are cracked and deformed, replace rubber bushings.
Refer to
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст