Nissan Frontier D22. Instruction — part 875
RFD-8
[C200]
FRONT OIL SEAL
9.
Hold the companion flange using Tool and tighten drive pinion
nut.
10. Install rear propeller shaft. Refer to
PR-8, "Removal and Installation"
.
Tool number
: KV38108300 (J-44195)
Drive pinion
nut
: 127 - 294 N·m (13 - 30 kg-m,
94 - 217 ft-lb)
APD032
REAR COVER GASKET
RFD-9
[C200]
C
E
F
G
H
I
J
K
L
M
A
B
RFD
REAR COVER GASKET
PFP:38320
Removal and Installation
EDS0012S
1.
MA-40, "Changing Differential Gear Oil"
2.
Remove rear cover and rear cover gasket.
3.
Install new rear cover gasket and rear cover.
4.
Tighten rear cover bolts.
5.
Fill final drive with recommended gear oil. Refer to
MA-12, "RECOMMENDED FLUIDS AND LUBRI-
.
Rear cover bolts
: 44 - 54 N·m (4.5 - 5.5 kg-m,
33 - 39 ft-lb)
RFD-10
[C200]
REAR FINAL DRIVE ASSEMBLY
REAR FINAL DRIVE ASSEMBLY
PFP:38300
Removal and Installation
EDS0012T
REMOVAL
CAUTION:
●
Be careful not to damage spline, sleeve yoke and front oil seal when removing propeller shaft.
●
Before removing the final drive assembly or rear axle assembly, disconnect the ABS sensor har-
ness connector from the assembly and move it away from the final drive/rear axle assembly area.
Failure to do so may result in the sensor wires being damaged and the sensor becoming inopera-
tive.
1.
Remove propeller shaft. Refer to
PR-8, "Removal and Installation"
●
Plug front end of transfer.
2.
Remove axle shaft. Refer to
.
INSTALLATION
●
Installation is in the reverse order of removal.
●
Fill final drive with recommended gear oil to the specified level
shown. Refer to
MA-39, "Checking Differential Gear Oil"
SPD123
REAR FINAL DRIVE ASSEMBLY
RFD-11
[C200]
C
E
F
G
H
I
J
K
L
M
A
B
RFD
Components
EDS0012U
LDIA0019E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст