Nissan Rogue. Instruction — part 936
PARKING BRAKE SYSTEM
PB-5
< PERIODIC MAINTENANCE >
C
D
E
G
H
I
J
K
L
M
A
B
PB
N
O
P
If any drag is found, verify the parking brake components are installed and adjusted correctly.
PB-6
< PERIODIC MAINTENANCE >
PARKING BRAKE SHOE
PARKING BRAKE SHOE
Inspection and Adjustment
INFOID:0000000011280104
1. Adjust parking brake pedal stroke. Refer to
PB-4, "Inspection and Adjustment"
2. Perform parking brake break-in (drag on) operation by driving vehicle under the following conditions:
• Drive forward
• Vehicle speed: Approx. 40 km/h (25 MPH) set (constant and forward)
• Parking brake operating force: Approx. 160 +30.0 N (16.3 +3.1 kg-f, 36.0 +6.7 lb-f)
• Time: Approx. 10 +5.0 seconds.
CAUTION:
To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after
every break-in operation.
3. After the break-in procedure, check parking pedal stroke of parking brake.
CAUTION:
If it is out of the specification, adjust again. Refer to
PB-4, "Inspection and Adjustment"
ADJUSTMENT AFTER INSTALLATION
1. Adjust the parking brake pedal stroke. Refer to
PB-4, "Inspection and Adjustment"
2. Rotate the disc brake rotor with the parking brake pedal released and check that there is no drag.
CAUTION:
If any drag is found, verify the parking brake components are installed and adjusted correctly.
PARKING BRAKE CONTROL
PB-7
< REMOVAL AND INSTALLATION >
C
D
E
G
H
I
J
K
L
M
A
B
PB
N
O
P
REMOVAL AND INSTALLATION
PARKING BRAKE CONTROL
Exploded View
INFOID:0000000011280105
USA Production
AWFIA1070ZZ
1.
Parking brake rear cable (RH)
2.
Parking brake rear cable (LH)
3.
Parking brake front cable
4.
Parking brake control
5.
Adjusting nut
6.
Parking brake switch
Front
PB-8
< REMOVAL AND INSTALLATION >
PARKING BRAKE CONTROL
Korea Production
Removal and Installation
INFOID:0000000011280106
REMOVAL
1. Remove instrument lower panel LH. Refer to
IP-23, "Removal and Installation"
.
2. Remove the knee protector. Refer to
.
3. Disconnect the harness connector from the parking brake switch.
4. Remove the parking brake switch.
5. Remove the parking brake control nuts and remove the parking brake control.
6. Remove adjusting nut from parking brake control.
7. Disconnect the parking brake front cable from the parking brake control.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Do not reuse the adjusting nut.
• Adjust the parking brake with new adjusting nut.Refer to
PB-4, "Inspection and Adjustment"
.
AWFIA1130ZZ
1.
Parking brake rear cable (RH)
2.
Parking brake rear cable (LH)
3.
Parking brake front cable
4.
Parking brake control
5.
Adjusting nut
6.
Parking brake switch
Front
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст