Nissan Rogue. Instruction — part 1205
TM-192
< PERIODIC MAINTENANCE >
[CVT: RE0F10D]
CVT FLUID
Never reuse O-ring.
14. Lift down the vehicle.
15. Stop the engine.
CVT SHIFT SELECTOR
TM-193
< REMOVAL AND INSTALLATION >
[CVT: RE0F10D]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
REMOVAL AND INSTALLATION
CVT SHIFT SELECTOR
Exploded View
INFOID:0000000011279411
Removal and Installation
INFOID:0000000011279412
REMOVAL
1. Apply the parking brake.
CAUTION:
Make sure the vehicle cannot move with the parking brake applied.
2. Move the shift selector with the following procedure.
• Remove shift lock override button cover (1) using suitable tool.
1.
Shift selector handle
2.
Lock pin
3.
Shift selector assembly
4.
Control cable
5.
Key interlock cable
6.
Shift selector handle cover
Front
AWDIA1214ZZ
: Front
ALDIA0499ZZ
TM-194
< REMOVAL AND INSTALLATION >
[CVT: RE0F10D]
CVT SHIFT SELECTOR
• Insert suitable tool into opening to depress the shift lock over-
ride button (1) in the direction (
) shown. Move shift selector
to “N” position while depressing shift lock override button.
3. Remove the shift selector handle with the following procedure.
a. Slide the selector lever handle cover (1) down.
CAUTION:
Do not damage the knob cover.
b. Pull out the lock pin (2) from the selector lever handle (3).
c.
Pull the selector lever handle and the selector lever handle
cover upwards to remove them.
4. Remove the center console assembly. Refer to
5. Shift the selector lever to “P” position.
6. Disconnect the shift selector connector (A) and remove harness
clip (B).
7. Disconnect the tip (A) of control cable and remove socket (B)
from the shift selector assembly.
: Front
ALDIA0530ZZ
JSDIA3654ZZ
JSDIA4144ZZ
JSDIA4145ZZ
CVT SHIFT SELECTOR
TM-195
< REMOVAL AND INSTALLATION >
[CVT: RE0F10D]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
8. Press the pawls (B) of the key interlock cable slider (A) while
sliding it in the direction of the casing cap (C), and separate the
adjusting holder (D) and slider (A) (if equipped).
9. Remove the key interlock cable from the shift selector (if
equipped).
10. Remove the shift selector assembly nuts (
) and remove the
shift selector assembly from the vehicle.
INSTALLATION
Installation is in the reverse order of removal.
Shift Selector
• Pay attention to the following when connecting the control cable to the shift selector assembly.
1. When connecting the control cable (1) to the shift selector
assembly (2), face the grooved surface of the rib (A) up and
insert the control cable until it stops.
NOTE:
Apply multi-purpose grease to control cable eye before installa-
tion.
2. Install the socket (A) onto the shift selector assembly.
CAUTION:
• Place the socket onto the shift selector assembly, then
fasten it in place from above.
• Check that the pulling on the socket does not disconnect
it.
Shift Selector Handle
• Follow the procedure below and place the shift selector handle onto the shift selector assembly.
(E)
:Key interlock rod
JSDIA1797ZZ
JSDIA4146ZZ
JSDIA1624ZZ
JSDIA1810ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст