Nissan Rogue. Instruction — part 1261
REAR WIPER AUTO STOP SIGNAL CIRCUIT
WW-47
< DTC/CIRCUIT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
REAR WIPER AUTO STOP SIGNAL CIRCUIT
Component Function Check
INFOID:0000000011280404
1.
CHECK REAR WIPER (AUTO STOP) OPERATION
CONSULT DATA MONITOR
1. Select “WIPER” in “Data Monitor” of “BCM”.
2. Operate the rear wiper.
3. Check that RR WIPER STOP changes to ON and OFF linked with the wiper operation.
Is the inspection result normal?
YES
>> Rear wiper auto stop signal circuit is normal.
NO
>> Refer to
.
Diagnosis Procedure
INFOID:0000000011280405
Regarding Wiring Diagram information, refer to
.
1.
CHECK REAR WIPER MOTOR AUTO STOP CIRCUITS FOR OPEN
1. Turn ignition switch OFF.
2. Disconnect BCM and rear wiper motor.
3. Check continuity between BCM harness connector terminal and rear wiper motor harness connector ter-
minal.
Is inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace harness.
2.
CHECK AUTO STOP CIRCUITS FOR SHORT TO GROUND
Check continuity between BCM harness connector terminal and ground.
Is inspection result normal?
YES
>> Replace BCM. Refer to
BCS-75, "Removal and Installation"
(with Intelligent Key system) or
135, "Removal and Installation"
(with Intelligent Key system).
NO
>> Repair or replace harness.
Monitor item
Condition
Monitor status
RR WIPER STOP
Rear wiper motor
Stop position
ON
Except stop position
OFF
BCM
Rear wiper motor
Continuity
Connector
Terminal
Connector
Terminal
B16
55
D506
2
Yes
BCM
Ground
Continuity
Connector
Terminal
B16
55
No
WW-48
< SYMPTOM DIAGNOSIS >
WIPER AND WASHER SYSTEM SYMPTOMS
SYMPTOM DIAGNOSIS
WIPER AND WASHER SYSTEM SYMPTOMS
Symptom Table
INFOID:0000000011280406
CAUTION:
Perform the “Self Diagnostic Result” with CONSULT before performing the diagnosis by symptom.
Perform the diagnosis by DTC if DTC is detected.
Symptom
Possible malfunction
Reference
Front wiper does not op-
erate in...
HI only
• Combination switch (wiper and washer
switch)
• Harness between combination switch (wip-
er and washer switch) and BCM
• BCM
Combination switch (wiper
and washer switch)
Refer to
system) or
(without Intelligent
Key system).
• IPDM E/R
• Harness between IPDM E/R and front wiper
motor
• Front wiper motor
Front wiper motor (HI) circuit
Refer to
Front wiper request signal (IPDM E/R)
Check “FR WIP REQ” in “Da-
ta Monitor” of “IPDM E/R”.
Refer to
.
LO and INT
• Combination switch (wiper and washer
switch)
• Harness between combination switch (wip-
er and washer switch) and BCM
• BCM
Combination switch (wiper
and washer switch)
Refer to
system) or
(without Intelligent
Key system).
• IPDM E/R
• Harness between IPDM E/R and front wiper
motor
• Front wiper motor
Front wiper motor (LO) circuit
Refer to
Front wiper request signal (IPDM E/R)
Check “FR WIP REQ” in “Da-
ta Monitor” of “IPDM E/R”.
Refer to
.
INT only
• Combination switch (wiper and washer
switch)
• Harness between combination switch (wip-
er and washer switch) and BCM
• BCM
Combination switch (wiper
and washer switch)
Refer to
system) or
(without Intelligent
Key system).
Front wiper request signal (IPDM E/R)
Check “FR WIP REQ” in “Da-
ta Monitor” of “IPDM E/R”.
Refer to
.
Any mode
—
Refer to
WIPER AND WASHER SYSTEM SYMPTOMS
WW-49
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
WW
N
O
P
Front wiper does not
stop in...
Any mode
Front wiper auto stop signal (IPDM E/R)
Refer to
.
• Combination switch (wiper and washer
switch)
• BCM
Combination switch (wiper
and washer switch)
Refer to
(with Intelligent Key
system) or
(without Intelligent
Key system).
Front wiper operates ab-
normally because...
Intermittent adjust-
ments cannot be made.
• Combination switch (wiper and washer
switch)
• Harness between combination switch (wip-
er and washer switch) and BCM
• BCM
Combination switch (wiper
and washer switch)
Refer to
(with Intelligent Key
system) or
(without Intelligent
Key system).
Wiper/washer will not
operate together.
• Combination switch (wiper and washer
switch)
• Harness between combination switch (wip-
er and washer switch) and BCM
• BCM
Combination switch (wiper
and washer switch)
Refer to
(with Intelligent Key
system) or
(without Intelligent
Key system).
Wipers will not return to
stop position (repeat-
edly operates for 10
seconds and then
stops for 20 seconds.
Wipers then stop oper-
ating).
• IPDM E/R
• Harness between IPDM E/R and front wiper
motor
• Front wiper motor
Front wiper auto stop signal
circuit
Refer to
.
Rear wiper does not op-
erate.
ON only
• Combination switch (wiper and washer
switch)
• Harness between combination switch (wip-
er and washer switch) and BCM
• BCM
Combination switch (wiper
and washer switch)
Refer to
(with Intelligent Key
system) or
(without Intelligent
Key system).
INT only
• Combination switch (wiper and washer
switch)
• Harness between combination switch (wip-
er and washer switch) and BCM
• BCM
Combination switch (wiper
and washer switch)
Refer to
(with Intelligent Key
system) or
(without Intelligent
Key system).
ON and INT
• Combination switch (wiper and washer
switch)
• Harness between combination switch (wip-
er and washer switch) and BCM
• BCM
Combination switch (wiper
and washer switch)
Refer to
(with Intelligent Key
system) or
(without Intelligent
Key system).
• BCM
• Harness between rear wiper motor and
BCM
• Harness between rear wiper motor and
ground
• Rear wiper motor
Rear wiper motor circuit
Refer to
Symptom
Possible malfunction
Reference
WW-50
< SYMPTOM DIAGNOSIS >
WIPER AND WASHER SYSTEM SYMPTOMS
Rear wiper does not
stop.
ON only
• Combination switch (wiper and washer
switch)
• BCM
Rear wiper motor circuit
Refer to
INT only
• Combination switch (wiper and washer
switch)
• BCM
Combination switch (wiper
and washer switch)
Refer to
system) or
(without Intelligent
Key system).
Rear wiper does not op-
erate normally.
Wiper is not linked to
the washer operation.
• Combination switch (wiper and washer
switch)
• Harness between rear wiper motor and
BCM
• BCM
Combination switch (wiper
and washer switch)
Refer to
system) or
(without Intelligent
Key system).
BCM
—
Rear wiper does not re-
turn to the Stop position
(Stops after a five-sec-
ond operation).
• BCM
• Harness between rear wiper motor and
BCM
• Rear wiper motor
Rear wiper auto stop signal
circuit
Refer to
Rear wiper stops after
operating for five sec-
onds when ignition
switch is turned ON.
Front and rear washer
motor does not operate.
Front and rear washer
motor does not operate
when the washing
windshield.
• Combination switch (wiper and washer
switch)
• Harness between combination switch (wip-
er and washer switch) and BCM
• BCM
Combination switch (wiper
and washer switch)
Refer to
system) or
(without Intelligent
Key system).
• Harness between rear combination switch
(wiper and washer switch) and front and
rear washer motor.
• Front and rear washer motor
Front and rear washer motor
circuit
Refer to
Symptom
Possible malfunction
Reference
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст