Nissan Note E12. Instruction — part 567
SEC-120
< SYMPTOM DIAGNOSIS >
SECURITY INDICATOR LAMP DOES NOT TURN ON OR BLINK
SECURITY INDICATOR LAMP DOES NOT TURN ON OR BLINK
Description
INFOID:0000000009567489
Security indicator lamp does not blink when power supply position is other than the ON position.
NOTE:
• Before performing the diagnosis, perform “Work Flow”. Refer to
• Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and
check each symptom.
Conditions of Vehicle (Operating Conditions)
Power supply position is other than the ON position.
Diagnosis Procedure
INFOID:0000000009567490
1.
CHECK SECURITY INDICATOR LAMP
Check security indicator lamp.
SEC-15, "VEHICLE SECURITY SYSTEM : System Description"
.
Is the inspection result normal?
YES
>> GO TO 2.
NO
>> Repair or replace the malfunctioning parts.
2.
CONFIRM THE OPERATION
Confirm the operation again.
Is the result normal?
YES
>> Check intermittent incident. Refer to
GI-41, "Intermittent Incident"
.
NO
>> GO TO 1.
NATS ANTENNA AMP.
SEC-121
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
REMOVAL AND INSTALLATION
NATS ANTENNA AMP.
Removal and Installation
INFOID:0000000009541301
REMOVAL
1. Remove cluster lid A. Refer to
IP-21, "Removal and Installation"
2. Release pawls and remove NATS antenna amp. (1).
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
NOTE:
• If NATS antenna amp. is not installed correctly, NVIS (NATS) system will not operate properly and "SELF-
DIAG RESULTS" on CONSULT screen will show "LOCK MODE" or "CHAIN OF IMMU-KEY".
• Initialization is not necessary when only the NATS antenna amp. is replaced with a new one.
ALKIA3179ZZ
SEC-122
< REMOVAL AND INSTALLATION >
PUSH-BUTTON IGNITION SWITCH
PUSH-BUTTON IGNITION SWITCH
Removal and Installation
INFOID:0000000009541302
REMOVAL
1. Remove NATS antenna amp. Refer to
SEC-121, "Removal and Installation"
2. Release pawls and remove push-button ignition switch (1).
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
ALKIA3180ZZ
REMOTE KEYLESS ENTRY RECEIVER
SEC-123
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
REMOTE KEYLESS ENTRY RECEIVER
Removal and Installation
INFOID:0000000009541303
REMOVAL
1. Remove the glove box assembly. Refer to
IP-25, "Removal and Installation"
2. Disconnect the harness connector (A) from remote keyless entry
receiver (1).
3. Remove screw (B) and remove remote keyless entry receiver.
INSTALLATION
Installation is in the reverse order of removal.
ALKIA3178ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст