Nissan Note E12. Instruction — part 632
TM-86
< SYSTEM DESCRIPTION >
[CVT: RE0F11A]
SYSTEM
IDLE NEUTRAL CONTROL : System Description
INFOID:0000000009019867
SYSTEM DIAGRAM
DESCRIPTION
If a driver has no intention of starting the vehicle in D position, TCM operates the low brake solenoid valve and
controls the oil pressure of the low brake to be low pressure. Therefore, the low brake is in the release (slip)
status and the power transmission route of transaxle is the same status as the N position. In this way, the tran-
saxle is in idling status and load to the engine can be reduced to improve fuel economy.
NOTE:
JSDIA2535GB
SYSTEM
TM-87
< SYSTEM DESCRIPTION >
[CVT: RE0F11A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
Provides idle neutral control when stop/start operation is not performed.
Idle Neutral Control Start Condition
Idle neutral control is started when all of the following conditions are fulfilled. However, during idle neutral con-
trol, idle neutral control is stopped when any of the following conditions is not met or idle neutral control contin-
ues 30 seconds.
NOTE:
Stops or prohibits the idle neutral control when the TCM and ECM detect that the vehicle is in one of the fol-
lowing conditions.
• Engine coolant temperature and CVT fluid temperature are the specified temperature or more, or the speci-
fied temperature or less.
• When a transaxle malfunction occurs.
• When the vehicle detects DTC and is in the fail-safe mode.
Idle Neutral Control Resume Condition
JPDIA1215GB
Driving environment
: Flat road or road with mild gradient
Selector lever position
: “D” position
Vehicle speed
: 0 km/h (0 MPH)
Accelerator pedal position
: 0.0/8
Brake pedal
: Depressed
Engine speed
: Idle speed
Turn signal lamp/hazard signal lamp
: Not activated
TM-88
< SYSTEM DESCRIPTION >
[CVT: RE0F11A]
SYSTEM
When the idle neutral control finishes, if the vehicle is driven at more than the specified speed and the idle
neutral control start conditions are satisfied, the idle neutral control starts again. If the vehicle has a malfunc-
tion, the idle neutral control does not start.
ON BOARD DIAGNOSTIC (OBD) SYSTEM
TM-89
< SYSTEM DESCRIPTION >
[CVT: RE0F11A]
C
E
F
G
H
I
J
K
L
M
A
B
TM
N
O
P
ON BOARD DIAGNOSTIC (OBD) SYSTEM
Description
INFOID:0000000009019870
This is an on board diagnosis system which records diagnosis information related to the exhaust gases. It
detects malfunctions related to sensors and actuators. The malfunctions are indicated by means of the mal-
function indicator lamp (MIL) and are stored as DTC in the ECU memory. The diagnosis information can be
checked using a diagnosis tool (GST: Generic Scan Tool).
Function of OBD
INFOID:0000000009019871
The GST is connected to the diagnosis connector on the vehicle and communicates with the on-board control
units to perform diagnosis. The diagnosis connector is the same as for CONSULT. Refer to
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст