Nissan Xterra. Instruction — part 611
HYDRAULIC LINE
ST-19
< REMOVAL AND INSTALLATION >
C
D
E
F
H
I
J
K
L
M
A
B
ST
N
O
P
HYDRAULIC LINE
Removal and Installation
INFOID:0000000009483754
CAUTION:
Do not reuse O-rings or copper sealing washers.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spill-
ing.
Refer to the following illustration for hydraulic line removal and installation.
AWGIA0195GB
1.
Reservoir tank
2.
Suction hose
3.
High pressure hose
4.
Oil cooler
5.
Steering gear assembly
6.
Reservoir tank
ST-20
< REMOVAL AND INSTALLATION >
HYDRAULIC LINE
7.
Reservoir tank bracket
8.
Return hose
9.
Hose clamps
10. Suction hose
11. Connector bolts
12. Copper sealing washers
13. Pressure sensor
14. O-ring
A.
Reservoir tank attachment
B.
Power steering pump connec-
tions
C.
Steering gear assembly con-
nections
D.
Low pressure hose
E.
High pressure hose
Genuine Nissan PSF or
equivalent
Front
STEERING COLUMN
ST-21
< UNIT DISASSEMBLY AND ASSEMBLY >
C
D
E
F
H
I
J
K
L
M
A
B
ST
N
O
P
UNIT DISASSEMBLY AND ASSEMBLY
STEERING COLUMN
Disassembly and Assembly
INFOID:0000000009483755
DISASSEMBLY
1. Remove the bolt from the upper joint, then remove the upper joint from the steering column assembly.
2. Remove the ignition switch tamper resistant self-shear screws, using a drill.
3. Remove the ignition switch from the steering column.
ASSEMBLY
Assembly is in the reverse order of disassembly.
CAUTION:
• Do not reuse the self-shear screws.
• Any time the ignition switch has been removed and installed,
the keys must be re-registered in the BCM. Refer to CONSULT
Immobilizer mode and follow the on-screen instructions.
1.
Steering column assembly
2. Upper joint
3.
Ignition switch
4.
Self-shear screw
WGIA0126E
WGIA0009E
ST-22
< UNIT DISASSEMBLY AND ASSEMBLY >
STEERING COLUMN
INSPECTION AFTER ASSEMBLY
When the steering wheel does not turn smoothly, check as follows:
1. Check the steering column for the following:
• Damage to the column tube or bearings
• Wear around the seal edges
• Corrosion or pitting around the seal sliding area
Replace the steering column as an assembly, if necessary.
CAUTION:
• Do not exert any axial load or impact to the steering column.
• Replace the column if it is depleted of grease, worn, damaged, or if any scratches or coating
separation is present on the shaft seal area.
2. If the vehicle has been in a collision, or if noises are heard com-
ing from the steering column, check column length. If out of
specification, replace the steering column as an assembly.
3. Check the tilt device for proper operation range.
Steering column
length (L)
: Refer to
AWGIA0147ZZ
Range (A)
: Refer to
WGIA0083E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст