Nissan Maxima. Instruction — part 169
AV-496
< REMOVAL AND INSTALLATION >
[COLOR DISPLAY - W/ BOSE]
STEERING SWITCH
STEERING SWITCH
Removal and Installation
INFOID:0000000009471410
REMOVAL
1. Remove the driver airbag module. Refer to
SR-12, "Removal and Installation"
.
2. Remove the steering wheel audio control switch screws (A).
3. Release the steering wheel audio control switch harness clips
(B).
4. Remove the steering wheel audio control switches (1).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA1132ZZ
AV
AUDIO ANTENNA
AV-497
< REMOVAL AND INSTALLATION >
[COLOR DISPLAY - W/ BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
AUDIO ANTENNA
Location of Antenna
INFOID:0000000009471411
Window Antenna Repair
INFOID:0000000009471412
ELEMENT CHECK
1. Attach probe circuit tester (ohm setting) to antenna terminal on
each side.
• When measuring continuity, wrap tin foil around the top of
probe. Then, press the foil against the wire with your finger.
AWNIA1765ZZ
1.
AV control unit
2.
AV control unit antenna feeder
3.
In-line connectors M103, M501
4.
Antenna amp.
5.
Window antenna
6.
Satellite radio antenna feeder
7.
Satellite radio antenna
SEL250I
SEL122R
AV-498
< REMOVAL AND INSTALLATION >
[COLOR DISPLAY - W/ BOSE]
AUDIO ANTENNA
2. If an element is broken, no continuity will exist.
3. To locate a break, move probe along element. Tester indication
will change abruptly when probe passes the broken point.
REPAIR EQUIPMENT
• Conductive silver composition (DuPont No. 4817 or equivalent)
• Ruler 30 cm (11.8 in) long
• Drawing pen
• Heat gun
• Alcohol
• Cloth
REPAIRING PROCEDURE
1. Wipe broken heat wire and its surrounding area clean with a
cloth dampened in alcohol.
2. Apply a small amount of conductive silver composition to tip of
drawing pen.
NOTE:
Shake silver composition container before use.
3. Place ruler on glass along broken line. Deposit conductive silver
composition on break with drawing pen. Slightly overlap existing
heat wire on both sides [preferably 5 mm (0.20 in)] of the break.
SEL252I
SEL253I
PIIA0215E
AV
AUDIO ANTENNA
AV-499
< REMOVAL AND INSTALLATION >
[COLOR DISPLAY - W/ BOSE]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
4. After repair has been completed, check repaired wire for conti-
nuity. This check should be conducted 10 minutes after silver
composition is deposited.
Do not touch repaired area while test is being conducted.
5. Apply a constant stream of hot air directly to the repaired area
for approximately 20 minutes with a heat gun. A minimum dis-
tance of 3 cm (1.2 in) should be kept between repaired area and
hot air outlet.
If a heat gun is not available, let the repaired area dry for 24
hours.
SEL012D
SEL013D
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст