Nissan Juke F15. Instruction — part 1371
C1716, C1717, C1718, C1719 TIRE PRESSURE SENSOR
WT-27
< DTC/CIRCUIT DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
YES
>> Replace tire pressure sensor the tire pressure as 438.60 kPa (4.47 kg/cm
2
, 63.60 psi) displayed.
WT-41, "Removal and Installation"
.
NO
>> Perform “DTC CONFIRMATION PROCEDURE” (self-diagnosis) again. Refer to
.
WT-28
< DTC/CIRCUIT DIAGNOSIS >
C1729 VEHICLE SPEED SIGNAL
C1729 VEHICLE SPEED SIGNAL
DTC Logic
INFOID:0000000012201855
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.
DTC CONFIRMATION PROCEDURE
With CONSULT
1. Drive the vehicle.
2. Stop the vehicle.
3. Perform self-diagnosis in “AIR PRESSURE MONITOR” of “BCM”.
Is DTC “C1729” detected?
YES
>> Proceed to
.
NO
>> INSPECTION END
Diagnosis Procedure
INFOID:0000000012201856
1.
PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for “ABS”.
Is any DTCs detected?
YES
>> Check the DTCs.
NO
>> GO TO 2.
2.
CHECK BCM INPUT/OUTPUT SIGNAL
Check BCM input/output signal values. Refer to
.
Is the inspection result normal?
YES
>> Check pin terminal and connection of each harness connector for malfunctioning conditions.
NO
BCS-94, "Removal and Installation"
DTC
Display Item
Malfunction detected condition
Possible causes
C1729
VHCL SPEED SIG ERR
Vehicle speed signal not detected.
• CAN communication
• BCM
• ABS actuator and electric unit (control unit) malfunction
POWER SUPPLY AND GROUND CIRCUIT
WT-29
< DTC/CIRCUIT DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
POWER SUPPLY AND GROUND CIRCUIT
Diagnosis Procedure
INFOID:0000000012201857
1.
CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Check BCM power supply and ground. Refer to
.
Is the inspection result normal?
YES
>> INSPECTION END
NO
>> Repair open circuit or short to ground or short to power in harness or connectors.
WT-30
< SYMPTOM DIAGNOSIS >
TPMS
SYMPTOM DIAGNOSIS
TPMS
Symptom Table
INFOID:0000000012201858
LOW TIRE PRESSURE WARNING LAMP SYMPTOM CHART
Diagnosis items
Symptom
(Ignition switch
ON)
Low tire pressure warning lamp
Cause
Action
Low tire pres-
sure warning
lamp
The low tire pres-
sure warning lamp
illuminates for 1
second, then turns
OFF.
Wake-up operation for all
tire pressure sensors at
wheels is completed.
No system malfunctions
The low tire pres-
sure warning lamp
repeats blinking
ON for 2 seconds
and OFF for 0.2
seconds.
Wake-up operation for all
tire pressure sensors at
wheels is not completed.
Perform the ID registration
for all tire pressure sensors
at wheels. Refer to
Low tire pres-
sure warning
lamp
The low tire pres-
sure warning lamp
blinks once.
The front left tire pres-
sure sensor is not acti-
vated.
Perform the ID registration
for the tire pressure sensor
at front left wheel. Refer to
.
The low tire pres-
sure warning lamp
repeats blinking
twice.
The front right tire pres-
sure sensor is not acti-
vated.
Perform the ID registration
for the tire pressure sensor
at front right wheel. Refer to
.
The low tire pres-
sure warning lamp
repeats blinking for
3 times.
The rear right tire pres-
sure sensor is not acti-
vated.
Perform the ID registration
for the tire pressure sensor
at rear right wheel. Refer to
.
The low tire pres-
sure warning lamp
repeats blinking for
4 times.
The rear left tire pressure
sensor is not activated.
Perform the ID registration
for the tire pressure sensor
at rear left wheel. Refer to
.
SEIA0592E
SEIA0593E
JPEIC0090GB
SEIA0595E
SEIA0596E
SEIA0597E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст