Nissan Juke F15. Instruction — part 970
LU-10
< PERIODIC MAINTENANCE >
[MR FOR NISMO RS MODELS]
ENGINE OIL
2. Disconnect harness connector at oil pressure sensor (1), and
remove oil pressure sensor using a deep socket (commercial
service tool).
CAUTION:
Never drop or shock oil pressure sensor.
3. Install oil pressure gauge [SST: ST25051001 (J-25695-1)] (A)
and hose [SST: ST25052000 (J-25695-2)] (B).
4. Start engine and warm it up to normal operating temperature.
5. Check oil pressure with engine running under no-load.
NOTE:
When engine oil temperature is low, engine oil pressure becomes high.
If difference is extreme, check oil passage and oil pump for oil leakage.
6. After the inspections, install oil pressure sensor as follows:
a. Remove old liquid gasket adhering to oil pressure sensor and engine.
b. Apply liquid gasket and tighten oil pressure sensor to specification.
Use Genuine RTV Silicon Sealant or equivalent.
c.
Check engine oil level.
d. After warming up engine, check that there is no leakage of engine oil with running engine.
Draining
INFOID:0000000012197473
WARNING:
• Be careful not to get burned, as engine oil may be hot.
• Prolonged and repeated contact with used engine oil may cause skin cancer. Try to avoid direct skin
contact with used engine oil. If skin contact is made, wash thoroughly with soap or hand cleaner as
soon as possible.
1. Warm up the engine, and check for engine oil leakage from engine components. Refer to
2. Stop the engine and wait for 10 minutes.
3. Loosen oil filler cap.
4. Remove drain plug and then drain engine oil.
2
: Starter motor
: Engine front
JPBIA4449ZZ
JPBIA0074ZZ
Engine oil pressure
: Refer to
Tightening torque
: Refer to
.
ENGINE OIL
LU-11
< PERIODIC MAINTENANCE >
[MR FOR NISMO RS MODELS]
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
Refilling
INFOID:0000000012197474
1. Install drain plug with new drain plug washer. Refer to
CAUTION:
Be sure to clean drain plug and install with new drain plug washer.
2. Refill with new engine oil.
Engine oil specification and viscosity: Refer to
MA-11, "Fluids and Lubricants"
CAUTION:
• The refill capacity depends on the engine oil temperature and drain time. Use these specifica-
tions for reference only.
• Always use oil level gauge to determine the proper amount of engine oil in the engine.
3. Warm up engine and check area around drain plug and oil filter for engine oil leakage.
4. Stop engine and wait for 10 minutes.
5. Check the engine oil level. Refer to
.
Tightening torque
: Refer to
.
Engine oil capacity
: Refer to
LU-12
< PERIODIC MAINTENANCE >
[MR FOR NISMO RS MODELS]
OIL FILTER
OIL FILTER
Removal and Installation
INFOID:0000000012197475
REMOVAL
1. Remove engine under cover.
2. Using oil filter wrench [SST: KV10115801 (J-38956)] (A), remove
oil filter.
CAUTION:
• Oil filter is provided with relief valve. Use genuine NISSAN
oil filter or equivalent.
• Be careful not to get burned when engine and engine oil
may be hot.
• When removing, prepare a shop cloth to absorb any
engine oil leakage or spillage.
• Completely wipe off any engine oil that adheres to engine
and vehicle.
INSTALLATION
1. Remove foreign materials adhering to the oil filter installation surface.
2. Apply new engine oil to the oil seal contact surface of new oil fil-
ter.
3. Screw oil filter instructionly until it touches the installation surface,
then tighten it by 2/3 turn (A). Or tighten to specification.
Inspection
INFOID:0000000012197476
INSPECTION AFTER INSTALLATION
1. Check the engine oil level. Refer to
.
2. Start the engine, and check that there is no leakage of engine oil.
3. Stop the engine and wait for 10 minutes.
4. Check the engine oil level, and adjust the level. Refer to
.
: Vehicle front
JPBIA4450ZZ
SMA010
Oil filter:
: 17.7 N·m (1.8 kg-m, 13 ft-lb)
JPBIA0077ZZ
OIL COOLER
LU-13
< REMOVAL AND INSTALLATION >
[MR FOR NISMO RS MODELS]
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
REMOVAL AND INSTALLATION
OIL COOLER
Exploded View
INFOID:0000000012197477
M/T models
JPBIA4444GB
1.
Clamp
2.
Water hose
3.
Oil cooler
4.
Water hose
: N·m (kg-m, in-lb)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст