Nissan Juke F15. Instruction — part 975
LU-30
< PERIODIC MAINTENANCE >
[MR EXCEPT FOR NISMO RS MODELS]
ENGINE OIL
CAUTION:
• The refill capacity depends on the engine oil temperature and drain time. Use these specifica-
tions for reference only.
• Always use oil level gauge to determine the proper amount of engine oil in the engine.
3. Warm up engine and check area around drain plug and oil filter for engine oil leakage.
4. Stop engine and wait for 10 minutes.
5. Check the engine oil level. Refer to
.
OIL COOLER
LU-31
< REMOVAL AND INSTALLATION >
[MR EXCEPT FOR NISMO RS MODELS]
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
REMOVAL AND INSTALLATION
OIL COOLER
Exploded View
INFOID:0000000012197498
M/T models
JSBIA5996GB
1.
Clamp
2.
Water hose
3.
Oil cooler
4.
Water hose
5.
O-ring
6.
Hose clip
7.
Water hose bracket
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
LU-32
< REMOVAL AND INSTALLATION >
[MR EXCEPT FOR NISMO RS MODELS]
OIL COOLER
CVT models
Removal and Installation
INFOID:0000000012197499
REMOVAL
1. Drain coolant. Refer to
CAUTION:
Allow the engine to cool before beginning.
2. Remove the front bumper. Refer to
EXT-17, "Removal and Installation"
.
3. Remove the charge air cooler. Refer to
EM-194, "Removal and Installation"
4. Disconnect each water hose.
5. Remove the oil cooler.
JSBIA5722GB
1.
Clamp
2.
Water hose
3.
Oil cooler
4.
Water hose
5.
O-ring
A.
To CVT fluid warmer
B.
To multi-way valve
: Always replace after every disassembly.
: N·m (kg-m, in-lb)
OIL COOLER
LU-33
< REMOVAL AND INSTALLATION >
[MR EXCEPT FOR NISMO RS MODELS]
C
D
E
F
G
H
I
J
K
L
M
A
LU
N
P
O
• Loosen bolts in the reverse order of the numerical order as
shown in the figure.
INSTALLATION
Note the following, and install in the reverse order of removal.
Oil Cooler
CAUTION:
Never reuse-ring. Always replace it with a new one.
• Tighten the oil cooler mounting bolts in numerical order as shown
in the figure.
Inspection
INFOID:0000000012197500
INSPECTION AFTER REMOVAL
Check visually and by other means for cracks or damage of the oil cooler. If any abnormality is found, replace
the oil cooler.
INSPECTION AFTER INSTALLATION
1. Use the oil level gauge and check that the oil level is within the standard. Refer to
2. Check the coolant level. Refer to
3. Start the engine. Check for engine oil or coolant leakage.
4. Stop the engine. After stopping it, leave it for 10 minutes or more.
5. Check the engine oil level and coolant level again. Fill or adjust fluid levels if necessary.
JSBIA5723ZZ
JSBIA5723ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст