Nissan Juke F15. Instruction — part 792
FRONT DRIVE SHAFT
FAX-107
< REMOVAL AND INSTALLATION >
[TYPE 2]
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
a. Put boot band in the groove on drive shaft boot. Then fit pawls
(
) into holes to temporary installation.
NOTE:
For the large diameter side, fit projection (A) and guide slit (B) at
first.
b. Pinch projection on the band with suitable pliers to tighten band.
c. Insert the tip of band into the lower part of pawl (marked with
dotted circle) as shown in the figure.
8. Check that displacement does not occur when boot is rotated with the housing assembly fixed.
CAUTION:
• If displacement occurs, reinstall band.
• Never reuse boot band.
9. Install dynamic damper, follow the procedure described below.
a. Install dynamic damper to shaft.
b. Secure dynamic damper with bands in the following specified
position (A) when installing.
CAUTION:
Never reuse bands.
c. Install boot bands securely as showin in the figure.
10. Install boot to the wheel side. Refer to
FAX-76, "AWD : Removal and Installation"
JPDIF0157ZZ
JPDIF0158ZZ
A :
.
JPDIF0178ZZ
PDIA1188J
FAX-108
< REMOVAL AND INSTALLATION >
[TYPE 2]
FRONT DRIVE SHAFT
AWD : Inspection
INFOID:0000000012201567
INSPECTION AFTER INSTALLATION
1. Check wheel sensor harness for proper connection. Refer to
BRC-147, "FRONT WHEEL SENSOR :
.
2. Check the wheel alignment. Refer to
.
3. Adjust neutral position of steering angle sensor. Refer to
.
SERVICE DATA AND SPECIFICATIONS (SDS)
FAX-109
< SERVICE DATA AND SPECIFICATIONS (SDS)
[TYPE 2]
C
E
F
G
H
I
J
K
L
M
A
B
FAX
N
O
P
SERVICE DATA AND SPECIFICATIONS (SDS)
SERVICE DATA AND SPECIFICATIONS (SDS)
Wheel Bearing
INFOID:0000000012201568
Drive Shaft
INFOID:0000000012201569
2WD
*: For measuring position, refer to
FAX-87, "2WD : Disassembly and Assembly"
AWD
*: For measuring position, refer to
FAX-101, "AWD : Disassembly and Assembly"
Item
Standard
Axial end play
0.05 mm (0.002 in) or less
Item
Standard
Left side
Right side
Grease quantity
Wheel side
115 – 125 g (4.05 – 4.40 oz)
Transaxle side
132 – 142 g (4.65 – 5.00 oz)
Boots installed length
*
Wheel side
97.1 mm (3.82 in)
Transaxle side
85.0 mm (3.35 in)
Dimension of dynamic damper
*
M/T models
267 – 273 mm (10.51 – 10.75 in)
257 – 263 mm (10.12 – 10.35 in)
CVT models
267 – 273 mm (10.51 – 10.75 in)
Item
Standard
Grease quantity
Wheel side
88 – 108 g (3.10 – 3.80 oz)
Transaxle side
126 – 136 g (4.45 – 4.79 oz)
Boots installed length
*
Wheel side
95.4 mm (3.75 in)
Transaxle side
93.8 mm (3.69 in)
Dimension of dynamic damper
*
267 – 273 mm (10.51 – 10.75 in)
FL-1
ENGINE
C
D
E
F
G
H
I
J
K
L
M
SECTION
FL
A
FL
N
O
P
CONTENTS
FUEL SYSTEM
MR16DDT
PRECAUTION . . . . . . . . . . . ...
PRECAUTIONS . . . . . . . . . . . . ...
General Precautions . . . . . . . . . . . .....
Precautions for Removing Battery Terminal . . .....
PREPARATION . . . . . . . . . . .
PREPARATION . . . . . . . . . . . . ...
Special Service Tool . . . . . . . . . . . .....
Commercial Service Tools . . . . . . . . . ....
PERIODIC MAINTENANCE . . . . . . ..
FUEL SYSTEM . . . . . . . . . . . . .
Inspection . . . . . . . . . . . . . . . . ..
Quick Connector . . . . . . . . . . . . . ...
REMOVAL AND INSTALLATION . . . .
FUEL LEVEL SENSOR UNIT, FUEL FILTER
AND FUEL PUMP ASSEMBLY . . . . . . ..
2WD . . . . . . . . . . . . . . . . . . .....
2WD : Exploded View . . . . . . . . . . . ...
2WD : Removal and Installation . . . . . . . ....
2WD : Disassembly and Assembly . . . . . . ...
2WD : Inspection . . . . . . . . . . . . . .
AWD . . . . . . . . . . . . . . . . . . ...
AWD : Exploded View . . . . . . . . . . . .
AWD : Removal and Installation . . . . . . . .
AWD : Disassembly and Assembly . . . . . . .
AWD : Inspection . . . . . . . . . . . . .
FUEL TANK . . . . . . . . . . . . . ..
2WD . . . . . . . . . . . . . . . . . . .
2WD : Exploded View . . . . . . . . . . . ..
2WD : Removal and Installation . . . . . . . ..
2WD : Inspection . . . . . . . . . . . . . .
AWD . . . . . . . . . . . . . . . . . . ...
AWD : Exploded View . . . . . . . . . . . .
AWD : Removal and Installation . . . . . . . ..
AWD : Inspection . . . . . . . . . . . . . .
EVAP CANISTER . . . . . . . . . . . ..
2WD . . . . . . . . . . . . . . . . . . .
2WD : Hydraulic Layout . . . . . . . . . . ...
2WD : Exploded View . . . . . . . . . . . ..
2WD : Removal and Installation . . . . . . . ..
2WD : Disassembly and Assembly . . . . . . ..
2WD : Inspection . . . . . . . . . . . . . .
AWD . . . . . . . . . . . . . . . . . . ...
AWD : Hydraulic Layout . . . . . . . . . . ..
AWD : Exploded View . . . . . . . . . . . .
AWD : Removal and Installation . . . . . . . ..
AWD : Disassembly and Assembly . . . . . . .
AWD : Inspection . . . . . . . . . . . . . .
SERVICE DATA AND SPECIFICATIONS
(SDS) . . . . . . . . . . . . . . .
SERVICE DATA AND SPECIFICATIONS
(SDS) . . . . . . . . . . . . . . . . .
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст